Heat & Glo LifeStyle XLR-PB-CE J. Lighting Instructions IPI, Final inspection by, Not For Use

J. Lighting Instructions (IPI)

The IPI system may be operated with two D-cell batteries. When using batteries, unplug the transformer. To prolong battery life, remove them when using the transformer.

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.

LIGHTING

INSTRUCTIONS (IPI)

1. This appliance is equipped with an ignition

device which automatically lights the burner.

DO NOT try to light the burner by hand.

A. This appliance is equipped with an intermittent pilot ignition (IPI) device which automatically lights the burn- er. DO NOT try to light the burner by hand.

B.BEFORE LIGHTING, smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•DO NOT try to light any appliance.

•DO NOT touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

•If you cannot reach your gas sup- plier, call the fire department.

C. DO NOT use this appliance if any part has been under water. Imme- diately call a qualified service tech- nician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

GAS

VALVE

2.	Wait five (5) minutes to clear out any gas.
	Then smell for gas, including near the floor. If
	you smell gas, STOP! Follow “B” in the Safety
	Information located on the left side of this la-
	bel. If you do not smell gas, go to next step.
3.	To light the burner:
	Equipped with wall switch: Turn ON/OFF switch
	to ON.

WARNING:	CAUTION:
DO NOT CONNECT LINE VOLT-	Hot while in operation. DO NOT touch.
AGE (110/120 VAC OR 220/240	Keep children, clothing, furniture, gaso-
VAC) TO THE CONTROL VALVE.	line and other liquids having flammable
Improper installation, adjustment, al-	vapors away.
	DO NOT operate the appliance with
teration, service or maintenance can
	fixed glass assembly removed, cracked
cause injury or property damage. Re-
	or broken. Replacement of the fixed
fer to the owner’s information manual
	glass assembly should be done by a
provided with this appliance.
	licensed or qualified service person.
This appliance needs fresh air for
safe operation and must be installed	NOT FOR USE
so there are provisions for adequate	WITH SOLID FUEL
combustion and ventilation air.
If not installed, operated, and main-	For use with natural gas and propane.
tained in accordance with the manufac-	A conversion kit, as supplied by the
turer’s instructions, this product could	manufacturer, shall be used to convert
expose you to substances in fuel or	this appliance to the alternate fuel.
fuel combustion which are known to the	Also Certified for Installation in a
State of California to cause cancer, birth
	Bedroom or a Bedsitting Room.
defects, or other reproductive harm.
	For assistance or additional informa-
Keep burner and control compartment
	tion, consult a qualified installer, ser-
clean. See installation and operating
	vice agency or the gas supplier.
instructions accompanying appliance.

For additional information on operating your

Hearth & Home Technologies fireplace, please refer to www.fireplaces.com.

Equipped with remote or wall control: Press

ON or FLAME button.

Equipped with thermostat: Set temperature to

desired setting.

4. If the appliance does not light after three tries,

call your service technician or gas supplier.

TO TURN OFF

GAS TO APPLIANCE

1.Equipped with wall switch: Turn ON/OFF switch to OFF.

Equipped with remote or wall control: Press OFF button.

Equipped with thermostat: Set temperature to lowest setting.

2.Service technician should turn off electric power to the control when performing service.

593-913G

Final inspection by

Heat & Glo • XLR-N-CE, XLR-PB-CE • 2198-900 Rev. J • 5/12 11