You can assemble your fan for standard or angled mounting as shown in steps 3-1 – 3-3. For low profilemounting (ceilings less than 8 feet high), go to steps 3-6 – 3-9 on the next page.
3-1. To assemble fan to hang down from a flat or angled ceiling, place the canopy and canopy trim ring around the adapter so that they rest on the fan assembly.
3-2. Feed the wires from the fan through the downrod.
Note: Make sure all the wires are on the same side of the metal dowel pin inside the dowrod.
3-3. Loosen the square head setscrew on the adapter to install the pipe and ball assembly. Note: When the pipe and ball assembly is fully installed, 2-3 threads on the pipe will still be visible; this is normal. Securely retighten the setscrew with a wrench or pliers.
CAUTION: The adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from unscrewing. Once assembled, do not remove the downrod.
WARNING: Do not carry or lift fan by canopy.
3-4. Raise the fan and place the ball into the hanger bracket.
3-5. Align the notch on the ball with the indent in the hanger bracket. (Rotate the fan until you hear the notch pop into place.)
Go to 4 • Wiring the Fan..
WARNING: Fan may fall if not assembled as directed in these installation instructions.
Indent