Troubleshooting
Fan doesn’t work
•Make sure power switch is on.
•Pull the pull chain to make sure it is on.
•Push the motor reversing switch firmly left or right to ensure that it is engaged.
•Check the circuit breaker to ensure the power is turned on.
•Make sure the blades spin freely.
•Turn off power from the circuit breaker, then loosen the canopy and check all the connections according to the wiring diagram on page 10.
•Make sure the battery is working.
•Check the plug connection in the switch housing.
Excessive wobbling
•Tighten all of the blade and blade iron screws until they are snug.
•Turn the power off, support the fan carefully, and check that the hanger ball is properly seated.
•Use the provided balancing kit and instructions to balance the fan.
Remote control of fan is erratic
•Make sure the battery is installed correctly.
•Install a fresh battery.
Transmitter only works when held at close range
•Change battery.
Noisy operation
•Tighten the blade and blade iron screws until they are snug.
•Check to see if any of the blades are cracked. If so, replace all of the blades.
Fan Runs Slowly
•Turn the power to the fan off at the wall switch. Then, turn it on again. Push the 3 button on the remote transmitter for high fan speed. Then, pull the fan speed chain until the fan is on the highest speed.
www.HunterFan.com 1.888.830.1326 
Lights dim when turned on or do not turn on at all.
•Make sure the wattage of the light bulbs installed matches the specifications on the light sockets.
20
