Oscillation Pin
Power/Speed
Control
Angle
Adjustment
Knob
FigURe 15
7.To adjust the height of your fan, hold the Telescoping Pole securely with one hand, and twist the Height Adjustment Grip counterclockwise. While supporting the fan motor, raise or lower the Telescoping Pole to the desired height, then tighten the Height Adjustment Grip.
Maintenance
This fan is permanently lubricated and will not require additional lubrication (oil) for the life of the fan.
This fan requires little maintenance and contains no user serviceable parts. DO NOT try to fix it yourself. Contact qualified service personnel if servicing is needed.
TO CLEAN:
1.Before cleaning, turn the fan off and remove the plug from
electrical outlet. Wipe off excess dust with a
2.To ensure adequate air circu- lation to the motor, keep the vents located at the rear of the motor housing free from dust accumulation. A vacuum cleaner hose can be used to clean these vents.
3.DO NOT immerse the fan in wa- ter or any other liquid.
CLEANING GRILLE AND BLADEs:
1.Turn the fan off and remove the plug from the electrical outlet.
2.To disassemble the Grille, un- latch the Grille Ring Latch, remove the Grille Ring and the Interlock Bracket.
3.Loosen the Blade Assembly Setscrew and slide the Blade As- sembly off of the Motor Shaft.
4.The Grilles and the Blade Assem- bly may be cleaned with mild soap and water.
5.Use a soft, slightly damp cloth to wipe the remaining fan parts.
6.DO NOT allow water or any other liquid to get into the mo- tor housing or base.
7.When the Blade Assembly and Grilles have dried completely, reassemble the fan following assembly steps 18 - 26 of this manual.
8.DO NOT plug fan into an elec- trical outlet until it has been fully reassembled.
ENGLISH
11 |