27. Place the Grille Ring over the Front and Back Grille rims, positioning the opening of the Grille Ring at the bottom of the Front and Back Grille rims. Bring the two ends of the Grille Ring together, and secure them with Grille Ring Latch. See Figure 14.

Grille Ring

ENGLISH

Grille Ring Latch

Latch Open

Latch Closed

FigURe 14

Operation

This appliance is for household use only.

1.Place the fan on a dry, safe, flat surface where it cannot fall or be pulled by the cord.

2.Plug the fan into a grounded 120-volt AC electrical outlet (ordinary household current). DO NOT use any other type of outlet. Make sure that the rated voltage of the fan is the same as the power source before plug- ging it into the power source.

3.Turn the fan “ON” or “OFF” by rotating clockwise or coun- terclockwise the Power/Speed Control. See Figure 15. The power should always be OFF be- fore unplugging the fan.

4.To select the speed, move the Power/Speed Control from OFF to the desired speed setting: O (off), I (low), II (medium), III (High).

5.To adjust the upward or down- ward flow of air, loosen the An- gle Adjustment Knob beneath the Fan Motor. See Figure 15. Position the fan to the desired angle, and tighten the Angle Adjust knob.

6.To make the fan oscillate, push the Oscillation Pin down. To stop the fan from oscillating, pull the Oscillation Pin up. See Figure 15.

10

41973-01 03/08/2006