Grill Assembly (Cont.)
1.Remove the Grill Ring from the Front Grill(11) by loosening the screw holding it.
2.Place the Front Grill(11) against the Back Grill(9) so the Hunter logo faces right side up and push together until the tabs on the grills hold them together. Figure 15.
3.Slide the Grill Ring over both Front(11) and Back(9) Grills turning it so the screw that will secure it is on the bottom. Figure 16.
4.Tighten the Screw to secure the Grill Ring over the Front and Back Grills.
5.Straighten the Cord from the Motor along the Telescoping Pole and Snap the Cord Clip over the cord onto the Pole so the cord rests in the notch on the Clip. Figure 18.
|
|
(9) Back Grill | Hunter Logo |
(11)Front Grill
Figure 15.
Screw
(12) Grill Ring
Figure 16.
Figure 17.
Cord
(13)Cord Clip
Notch
Figure 18.
©2010 Hunter Fan Co. | 10 |
