Hunter Fan Type Assembling and Hanging the Fan, For Standard or Angled mounting

3 • Assembling and Hanging the Fan

WARNING: Fan may fall if not assembled as directed in these installation instructions.

3.1 Unbundle the wires from the fan.

For Standard or Angled mounting:

3.2Insert the downrod through the canopy and canopy trim ring. Feed the wires from the fan through the downrod on one side of the pin in the ball.

3.3Loosen the square head setscrew on the adapter to install the pipe and ball assembly. Note: When the pipe and ball assembly is fully installed, 2-3 threads on the pipe will still be visible; this is normal. Securely retighten the setscrew with a wrench or pliers. Skip to step 3.7.

CAUTION: The adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from unscrewing. Once assembled, do not remove the downrod.

For Low Profile mounting:

Note: For low profile mounting, the downrod is replaced with the low profile washer.

3.4Remove the setscrew from the adapter.

3.5Place the low profile washer into the canopy with the lip down.

3.6Align the holes in the washer with the holes in the adapter. Assemble securely with three low profile screws.

Hanging the Fan:

Note: To hang the fan, you must tilt the canopy to an almost vertical position so that the canopy slots sit on the ceiling plate hooks.

3.7Raise the fan and align the slots in the canopy with the hooks on the ceiling plate.

3.8Place the slots over the hooks to hang the fan.

Standard or Angled Mounting

Steps 3-2 –	3-3
	Downrod
	Canopy
	Canopy
Setscrew	Trim Ring

Low Profile Mounting

Steps 3-5 – 3-6	Low Profile Screws
Green	Low Profile
	Washer
Ground
Wire
Canopy	Canopy
Trim Ring

Low Profile Screw

Step 3-6 (Detail)

Adapter Low Profile Screw

Low Profile

Washer

8

42606-01 • 06/27/11 • Hunter Fan Company