Husky 1800PSI Gun at a rate equal to the Garden Hose, Wand Attaching, Wand Removing, Greater

PROBLEM OR CONCERN			POSSIBLE CAUSE	SOLUTION
Unit will not stop when trigger is			Wand is malfunctioning	Test both wands to ensure that one is not
released (contd)				malfunctioning.
			Gun is not operating properly	Remove Wand from the Gun and squeeze trigger to
				ensure that the water is coming out of the front of the
				Gun at a rate equal to the Garden Hose.
Wand - Attaching				ToattachtheWandapplysomemoderatedownward
				pressure force on the Wand (In the direction of the
				trigger) while simultaneously twisting the wand a 1/4
				of a turn counterclockwise. (It may help if you set the
				gun vertically on a flat surface with the wand pointing
				upwards). The two tabs on the end of the Wand must
				slide all the way in before the Wand will twist and
				lock. If this does not work remove the o-ring from the
				end of the wand and attach it without the o-ring. If the
				wand attaches, you will need to replace the o-ring.
				Contact us at:
				customerservice@huskypowerwasher.com
				or order a replacement directly online at:
				www.huskypowerwasher.com.
Wand - Removing				Release the back pressure in the Gun/Hose.
				Remove the Garden Hose from the unit and
				squeeze the trigger of the Gun. Apply some
				moderate downward pressure force on the
				Wand (In the direction of the trigger) while
				simultaneously twisting the wand a 1/4 of
				a turn clockwise. (It may help if you set the
				gun vertically on a flat surface with the Wand
				pointing upwards). For additional assistance
				you can email us at:
				customerservice@huskypowerwasher.com.
The green “Ready” light is not			No power	Reset GFCI according to the procedure in
illuminated.				Owner’s Manual section 3.3. Check that the
NOTE: The green “Ready” light				circuit is dedicated and rated at 15 amps or
should illuminate when the machine				greater.
is plugged in and the ON button is
depressed.
The yellow “Medium” light will			The Click-N-CleanTMis not set	Make sure that the Click-N-CleanTMwand is set
not illuminate.			to the proper position.	to the “Medium Fan Spray” or “Detergent Spray”
NOTE: The yellow “Medium” light				position.
will only illuminate when using the
turbo wand or the Click-N-CleanTM			Use of improper extension	Use proper extension cord as recommended in
wandsettothe“MediumFanSpray”			cord.	Owner’s Manual.
or “Detergent Spray” position and
the gun trigger is depressed motor is
			Clogged nozzle	Clean nozzle as instructed in Owner’s Manual
running and water is spraying from
the nozzle.				section 5.2.
The blue	“High” light	will not	Faucet not fully open or unit is	Ensure that the faucet is fully open.
illuminate.			not receiving a full volume of	Check garden hose connection and ensure that
NOTE: The blue “High” light will			water.	the garden hose meets criteria as described in the
only illuminate when the Click-N-				Owner’s Manual.
CleanTM wand is set to the “High
			Screen filter clogged.	Clean the screen filter as instructed in Owner’s
Pressure	Fan Spray”	position		Manual section 5.4.
and the gun trigger is depressed,
motor is running and water is
spraying from the nozzle.

26