Charging with 12 VOLT DC Adapter - Plug the DC fused Recharge Adapter (included) into the Recharge Port (barrel receptacle) just behind the rubber Bezel and then insert the ciga- rette lighter plug into the cigarette lighter socket of your vehicle or other 12 VDC power source. Make sure the Locking Trigger Switch is in the OFF position. Allow approximately 3 hours charging time if the engine is running.
WARNING: Use the supplied DC Recharge Adapter, do not substitute.
1.Move the rubber plug from the Recharge Port. It is there to keep out dust and moisture.
2.Connect the DC Recharge Adapter’s large cigarette lighter type plug to a 12 volt DC source.
3.Plug the adapter’s barrel connecter into the Recharge Port located near the rubber bezel.
4.Recharge for 3 hours maximum.
5.After recharge, disconnect the barrel connector from the Recharge Port and store the adapter.
6.Replace the rubber plug in the Recharge Port.
AC RECHARGE
Make sure that the AC source is 110/120 volts, 60 Hz.
WARNING: Use the supplied AC Recharge adapter, do not substitute with any other.
1.Lift the rubber plug from the Recharge Port. (see figure 3) It is there to keep out dust and moisture.
2.Connect the AC adapter into wall outlet. (see figure 3)
3.Plug the adapter’s barrel connecter into the Recharge Port.
4.Recharge for 10 hours maximum.
5.After recharge, disconnect the barrel connector from the Recharge Port and store the adapter.
6.Replace the rubber plug in the Recharge Port.
4.PERIODIC MAINTENANCE
All batteries lose charge over time, especially when they are warm. AC recharge is recom- mended every two months, when not in frequent use. Use the AC recharger and charge for the recommended time. If the unit gets dirty, gently clean the outer surfaces of the spotlight unit with a soft cloth moistened with a mild solution of water and detergent.
5.PARTS REPLACEMENT
Three parts are replaceable by users. The quartz halogen bulb and sealed lead acid battery are proprietary and are available through HUSKY. A substitute 6 volt H3 55 watt bulb may be used instead of a HUSKY bulb. These can also be purchased from popular automotive parts suppliers nationwide. The DC charging adapter fuse is replaceable. Contact HUSKY’s Technical Support De- partment for replacement parts and any additional information that you may need. They may be reached toll free (800)
DC PLUG FUSE REPLACEMENT
The fuse in the DC plug protects the charging circuit of the DC Recharge Adapter. This fuse may blow if the spotlight is operated when the DC Recharge Adapter is powered and the DC cord is connected to the recharge port. During DC recharge, if there is no slight warming of the DC plug, you should suspect that 6 volts DC is not powering the plug or the fuse is opened.
To replace the fuse:
1.Unscrew the end cap of the DC Plug. (counterclockwise)
2.Remove spring center contact and fuse.
3.Check fuse with a continuity checker.
4.If blown, locate replacement fuse with same type and rating.
5.Replace the fuse, spring, contact and end cap.
6.Screw end cap clockwise until it is finger
7.Check for proper operation of DC Charger Adapter.
SPOTLIGHT BULB REPLACEMENT
To replace the H3 type 6 volt bulb, you will need a small Phillips type screwdriver and a replace-
4
