Operation (continued)
Vacuuming Dry Materials
1.The filter must always be in correct position to reduce the risk of leaks and possible damage to vac. Make sure that the filter is completely covering the filter cage and that the retainer band is as close to the lid as possible. Make sure there are no gaps between the filter and the lid. (See illustration). It is very important to assemble the filter to the cage without allowing any possible leaks or tears. Any leaks will allow the picked up media to be blown out of the blower port and back into the surrounding environment.
Filter
Retainer
Band
2.To maintain peak performance of your vac when picking up small debris such as sawdust, it may be helpful to empty the dust drum and clean or replace the filter at more frequent intervals.
NOTE: The filter should be dry to pick up dry material. If you use your vac to pick up dry debris when the filter is wet, the filter will clog quickly and be very difficult to clean.In case the filter gets wet, replace it before continuing dry pickup.
Vacuuming Liquids
1.Removal of the filter is highly recommended for wet pickups.
2.This wet/dry vac is equipped with a float mechanism which will rise automatically to cut off the airflow when the liquid in the drum reaches a predetermined level. When this happens, turn off vac, unplug the power cord, and empty the dust drum. You will know that the float has shut the airflow off because the suction ceases and the motor noise becomes higher in pitch, due to increased motor speed. The liquid capacity may vary with the rate of pickup.
3.Be sure to replace filter after wet pickup. Never pick up dry debris without the filter properly installed.
IMPORTANT: To reduce the risk of damage to the vac, do not run motor with float in raised position.
!WARNING: Never leave vac running while unattended.
Float In
Raised
Position
8
