ASSEMBLY
Blower/Drive Kit
1.Open the drive kit box and remove all of the components.
2.Place the deck in the lowest cutting height.
3.Remove the right side belt shield from the deck.
4.Remove the deck belt from the right side pulley.
5.Remove the deck pulley.
Note: When the deck pulley is removed, the spindle can fall out of the cutter housing assembly. Be sure to secure the bottom of the spindle so that this does not happen.
6.Place the double pulley on the cutter housing assembly.
7.Place the heavy washer, and 7/16 lock washer on the 108951, 7/16 x 2 1/2 bolt and install in the spindle. Torque to 45 ft/lbs.
8.Remove the discharge chute from the deck. Verify that the belt is on the pulley in the blower.
9.Place the deck plate pin in the tube on the back edge of the deck. Rotate the blower around and into place. Figure 1.
10.Install the pin thru the tabs on both the deck and the blower. Figure 1.
11.Latch the idler arm in the idler keeper. Figure 1.
12.Install the belt on the deck pulley and release the idler arm from the keeper.
13.Install the new belt shield.
14.Place the hose on the blower housing and secure with the over center hose clamp.
| 1 |
3 | 2 |
| |
| 4 |
| 5 |
FIGURE 1
1.DECK PLATE PIN
2.TUBE
3.ROTATE
4.IDLER ARM
5.IDLER KEEPER
11
