KEY to Symbols, Symbols on the machine | Husqvarna 1153177-26

KEY TO SYMBOLS

Symbols on the machine:

WARNING! Chain saws can be dangerous! Careless or incorrect use can result in serious or fatal injury to the operator or others.

Please read the operator’s manual carefully and make sure you understand the instructions before using the machine.

Always wear:

•Approved protective helmet

• Approved hearing protection

• Protective goggles or a visor

This product is in accordance with applicable EC directives.

Noise emission to the environment according to the European Community’s Directive. The machine’s emission is speciﬁed in chapter Technical data and on label.

Chain brake, activated (right) Chain brake, not activated (left)

Other symbols/decals on the machine refer to special certiﬁcation requirements for certain markets.

Symbols in the operator’s manual:

Switch off the engine by moving the stop switch to the STOP position before carrying out any checks or maintenance.

Always wear approved protective gloves.

Regular cleaning is required.

Visual check.

Protective goggles or a visor must be worn.

Filling with oil and adjusting oil ﬂow.

The chain brake must be engaged when the chain saw is started.

WARNING! Kickback may occur when the nose or tip of the guide bar touches an object, and cause a lightning fast reverse reaction, kicking the guide bar up and towards the operator. May cause serious personal injury.

2 – English

Image 2

Husqvarna 1153177-26 KEY to Symbols, Symbols on the machine, Symbols in the operator’s manual

Contents

395XP, 395XPG Symbols in the operator’s manual KEY to SymbolsSymbols on the machine Contents Introduction Dear Customer What is WHAT? What is what on the chain saw? General Safety Precautions Before using a new chain saw Personal protective equipment Machine′s safety equipmentAlways use common sense Chain brake and front hand guard General Safety Precautions Right hand guard Throttle lockoutChain catcher Vibration damping system Stop switchCutting equipment Mufﬂer Cutting equipment designed to reduce kickback Sharpening instructions considerably Sharpening your chain and adjusting depth gauge settingGeneral information on sharpening cutting teeth Increases the risk of kickback Tensioning the chain General advice on adjusting depth gauge settingAdjustment of depth gauge setting Too large Filling with chain oil Lubricating cutting equipmentWhich could lead to serious, even fatal injuries Chain oil Checking chain lubrication Checking wear on cutting equipment Chain drive sprocketNeedle bearing lubrication Operator Fitting a spike bumper AssemblyFitting the bar and chain Working with the chain Fuel Handling Fuel Transport and storage Fuel safetyFuelling Long-term storage Cold engine Starting and StoppingStarting and stopping Warm engine Stopping Before use Basic safety rulesWorking Techniques General working instructions Jam. Always stop the engine before cleaning Handles with both hands Basic cutting techniqueNot safely controlled with one hand General Logs are lying together. Such Procedures drastically increase the riskLimbing Or fatal injury Felling direction Tree felling techniqueSafe distance Clearing the trunk and preparing your retreat Directional cuts Felling cut Freeing a tree that has fallen badly How to avoid kickbackWhat is kickback? Cutting the trunk into logs Carburettor with movement limiters MaintenanceCarburettor adjustment Carburettor without movement limiters Recommended engine speeds are as follows Checking brake band wear Checking the front hand guard Checking the inertia brake release Immediately Mufﬂer Changing a broken recoil spring Changing a broken or worn starter cordTensioning the recoil spring Lubricating the bar tip sprocket Air ﬁlterSpark plug Fitting the starter Needle bearing lubrication Adjustment of the oil pumpAir Injection centrifugal cleaning Cooling system Winter use Heated handles Maintenance schedule Daily maintenance Weekly maintenance Monthly maintenance Technical Data Technical data Bar and chain combinations Saw chain ﬁling and ﬁle gauges EN ISO 12100-22003, Cispr 122005, EN ISO EC-declaration of conformityApplies to Europe only Page Original instructions 1153177-26