Fitting other guards and cutting attachments

ASSEMBLY

Fitting a trimmer guard and Superauto II 1” trimmer head

		K
K	G
K	F	B
	I	B
J	I	C
	I
		A

•Fit the correct trimmer guard (A) for use with the trimmer head. Hook the guard onto the ﬁtting on the shaft and secure it with the bolt (L).

•Fit the drive disc (B) on the output shaft.

•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.

•Insert the locking pin (C) in the hole to lock the shaft.

•To ﬁt the trimmer head, ﬁrst separate the two halves (see diagram). Proceed as follows:

•Insert a ﬁnger into the centre hole of the cover (I) while grasping the cover with your other ﬁngers. Using the index ﬁnger and thumb of your other hand, release the two catches (J) that engage in the cut-outs in the bottom half (K). Pull apart the trimmer head, grasping the cover ﬁrmly.

•Place the cover (I) and the support ﬂange (F) on the output shaft. Ensure that the drive disc’s guide locates correctly in the cover’s centre hole.

•Fit the nut (G). The nut must be tightened to a torque of 35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool kit. Hold the shaft of the spanner as close to the blade guard as possible. To tighten the nut, turn the spanner in the opposite direction to the direction of rotation (Caution! left-hand thread).

•Fit the bottom half of the trimmer head (K) to the cover

(I) by pressing them together, with the cut-outs on the bottom half aligned with the catches on the cover.

•To dismantle, follow the instructions in the reverse order.