ASSEMBLY
EN
Assembling the J-handle
!WARNING
Only grass blades or trimmer heads/ plastic blades may be used when the J- handle is fitted. Clearing blades must never be used with the
•Clip the loop handle onto
the shaft. Note that the loop handle must be fitted between the arrows on the shaft.
• Slide the spacer into the slot in the loop handle.
• Fit the nut, bolt and knob. Do not overtighten.
• Attach the
• Now adjust the trimmer to give a comfortable working position. Tighten
Assembly of the blade and trimmer head
It is extremely important that the disc drive’s/support flange’s guide engages correctly in the cutting equipment’s centre hole when assembling the cutting equipment. Cutting equipment assembled incorrectly can result in serious and/or fatal personal injury.
!WARNING!
Under no circumstances may the cutting equipment be used without an approved guard fitted. See the chapter “Technical data”. If the wrong guard or a defective guard is fitted this can cause serious personal injury.
Do not attach any blade to the unit without proper installation of all required parts. Failure to use the proper parts can cause the blade to fly off and seriously injure the operator and/or bystanders.
Fitting the combination guard, grass blade and grass knife
the bolt/knob.
Fitting the suspension ring
Fit the suspension ring between the rear handle and the loop handle. Position the suspension ring so that the machine is balanced and comfortable to work with.
•Hook the guard (A) onto the bracket on the shaft and secure with 1 bolt. NOTE! Use the recommended blade guard. “See Technical data“.
•Fit the drive disc (B) on the output axle.
•Turn the blade axle until one of the holes in the drive disc aligns with the hole in the gear housing.
•Insert the locking pin (C) in the hole so that the axle is locked.
•Place the blade (D), support cup (E) and support flange (F) on the output axle.
•Fit the nut (G). The tightening torque of the nut is
| G |
| F |
| E |
| D |
A | B |
| |
| C |
English – 5