OPERATION
GASOLINE
FILLER CAP
MUFFLER
CHOKE 
CON-
ELECTRIC |
| DISCHARGE CHUTE CONTROL LEVER | |||
START | AUGER |
| DEFLECTOR | TRACTION | |
BUTTON |
| DRIVE | |||
RECOIL | CONTROL | DRIVE SPEED | REMOTE | CONTROL | |
LEVER | CONTROL | ||||
CONTROL LEVER | LEVER | ||||
(AUXILIARY) |
| LEVER | |||
|
|
| |||
STARTER |
|
|
|
| |
HANDLE |
|
|
|
| |
| CHUTE |
|
|
| |
DEFLECTOR |
|
|
| ||
TROL
PRIMER
SAFETY IGNITION KEY
FUEL
VALVE THROTTLE / ENGINE CONTROL
LH TURN |
TRIGGER |
DISCHARGE
CHUTE
LIGHT
HANDLE KNOB
MUFFLER
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
AUGERS
FIG. 10
TOOLBOX
DRIFT
CUTTER
SKID PLATE
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and | Drive speed control lever - used to select forward or |
wrench. | reverse motion and speed of snow thrower. |
Safety ignition key - must be inserted for the engine to | Traction drive control lever - used to engage power- |
start and run. Remove when snow thrower is not in use. | propelled forward or reverse motion of snow thrower. |
Electric start button – used for starting the engine. | LH and RH turn triggers - used to steer the snow thrower. |
Recoil (auxiliary) starter handle – used for starting the | Auger control lever - used to engage auger motion (throw |
engine. | snow). |
Primer - pumps additional fuel from the carburetor to the | Discharge chute control lever - used to change the di- |
cylinder for use when starting a cold engine. | rection the snow is thrown. |
Throttle/engine control - used to select either FAST or | Skid plate - used to adjust height of scraper bar from the |
SLOW engine speed and to STOP the engine. | ground. |
Choke control - used for starting a cold engine. | 9 Drift cutter - used to cut through deep snowdrifts. |
