Husqvarna 223R Fitting a blade guard, grass blade and grass cutter, Fitting a trimmer guard and Superauto II 1" trimmer head

12 – English

ASSEMBLY

Fitting a blade guard, grass blade and grass cutter

• Hook the blade guard/combination guard (A) onto the

ﬁtting on the shaft and secure with the bolt.

CAUTION! Use the recommended blade guard. See the

Technical data section.

• Fit the drive disc (B) on the output shaft.

• Turn the blade shaft until one of the holes in the drive disc

aligns with the corresponding hole in the gear housing.

• Insert the locking pin (C) in the hole to lock the shaft.

• Place the blade (D), support cup (E) and support ﬂange

(F) on the output shaft.

• Fit the nut (G). The nut must be tightened to a torque of

35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool

kit. Hold the shaft of the spanner as close to the blade

guard as possible. To tighten the nut, turn the spanner in

the opposite direction to the direction of rotation (Caution!

left-hand thread).

Fitting a trimmer guard and Superauto II 1" trimmer head

•Fit the correct trimmer guard (A) for use with the trimmer

head. Hook the trimmer guard/combination guard onto

the ﬁtting on the shaft and secure with the bolt (L).

• Fit the drive disc (B) on the output shaft.

• Turn the blade shaft until one of the holes in the drive disc

aligns with the corresponding hole in the gear housing.

• Insert the locking pin (C) in the hole to lock the shaft.

• To ﬁt the trimmer head, ﬁrst separate the two halves (see

diagram). Proceed as follows:

Insert a ﬁnger into the centre hole of the cover (I) while

grasping the cover with your other ﬁngers. Using the index

ﬁnger and thumb of your other hand, release the two

catches (J) that engage in the cut-outs in the bottom half

(K). Pull apart the trimmer head, grasping the cover ﬁrmly.

• Place the cover (I) and the support ﬂange (F) on the

output shaft.

• Fit the nut (G). Tighten the nut to a torque of 35-50 Nm

(3.5-5 kpm). Use the socket spanner in the tool kit. Grasp

the handle of the spanner as close to the trimmer guard

as possible.

• To tighten the nut, turn the spanner in the opposite

direction to the direction of rotation (Caution! left-hand

thread).

• Fit the bottom half of the trimmer head (K) to the cover (I)

by pressing them together, with the cut-outs on the bottom

half aligned with the catches on the cover.

• To dismantle, follow the instructions in the reverse order.