ASSEMBLY
arrow in the diagram shows the area where you should operate the socket spanner when loosening or tightening the nut.
Fitting the blade guard and saw blade (235R)
•Remove the mounting plate (H). Fit the adapter (I) and bracket (J) with the two screws (K) as shown. Fit the blade guard (A) to the adapter using the 4 screws (L) as shown.
K
J
H
I
A
L
CAUTION! Always use the recommended guard for the cutting attachment you are using. See chapter on Technical data.
G
F
D
B 
C
•Fit the drive disc (B) on the output shaft.
•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.
•Insert the locking pin (C) in the hole to lock the shaft.
•Place the blade (D) and support flange (F) on the output shaft.
•Fit the nut (G). The nut must be tightened to a torque of
guard as possible. To tighten the nut, turn the spanner in the opposite direction to the direction of rotation (Caution!
•When loosening and tightening the saw blade nut, there is a risk of injury from the teeth of the saw blade.You should therefore always ensure that your hand is shielded by the blade guard when doing this. Always use a socket spanner with a shaft that is long enough to allow this. The arrow in the diagram shows the area where you should operate the socket spanner when loosening or tightening the nut.
Fitting a trimmer guard and Superauto II 1" trimmer head (232R)
K
G
F
K IB
C
J M
I L 
A
•Fit the correct trimmer guard (A) for use with the trimmer head. Secure the trimmer guard using the 4 screws (L) and the support plate (M) as shown.
•Fit the drive disc (B) on the output shaft.
•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.
•Insert the locking pin (C) in the hole to lock the shaft.
•To fit the trimmer head, first separate the two halves (see diagram). Proceed as follows:
•Insert a finger into the centre hole of the cover (I) while grasping the cover with your other fingers. Using the index finger and thumb of your other hand, release the two catches (J) that engage in the
(K). Pull apart the trimmer head, grasping the cover firmly.
English – 15
