ASSEMBLY
•Place the cover (I) and the support flange (F) on the output shaft.
•Fit the nut (G). Tighten the nut to a torque of
•Fit the bottom half of the trimmer head (K) to the cover (I) by pressing them together, with the
•Screw on the trimmer head (H) in the opposite direction to the direction of rotation.
H
•Tighten the trimmer head to a torque of
•To dismantle, follow the instructions in the reverse order.
Fitting other guards and cutting attachments (232R)
•To dismantle, follow the instructions in the reverse order.
A
M
L B
C
Fitting the trimmer guard and trimmer head Trimmy SII (235R)
•Fit the correct trimmer guard (A) for use with the trimmer head. CAUTION! Ensure that the guard extension is fitted.
Hang the trimmer guard/combination guard (A) on the two hooks on the plate holder (M). Bend the guard around the shaft and tighten it with the bolt (L) on the opposite side of the shaft. Use the locking pin (C). Place the locking pin in the groove on the screw head and tighten. See diagram.
H
L
M
C B
A
AM L
•Fit the drive disc (B) on the output shaft.
•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.
•Insert the locking pin (C) in the hole to lock the shaft.
•Fit the trimmer guard/combination guard (A) intended for use with the trimmer head/plastic blades. Secure the trimmer guard/combination guard using four screws (L) and the support plate (M) as shown.
•Fit the drive disc (B) on the output shaft.
•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.
•Insert the locking pin (C) in the hole to lock the shaft.
•Screw on the trimmer head/plastic blades (H) in the opposite direction to the direction of rotation.
H
H
16 – English
