ASSEMBLY
Fitting the handlebar
(265RX)
•Fit the left handlebar in the handlebar mounting.
•Fit the right handle to the handlebar.
•Adjust roughly and tighten the screws slightly.
•Now make a final adjustment, with the machine hanging from the harness, to obtain the most comfortable working position. Tighten the screws.
•Make the final adjustment to the right handle and lock it in the most comfortable position.
Adjusting the throttle trigger
The throttle trigger can be adjusted to give the best working position. This is done using the Allen screws by the right handle.
Assembling the cutting equipment
WARNING!
! When fitting the cutting attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury.
WARNING! Never use a cutting attachment
!without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury.
IMPORTANT! If a saw blade or grass blade are to be used the machine must be equipped with the correct handlebar, blade guard and harness.
Fitting a blade guard, grass blade and grass cutter
•The blade guard (A) is fitted using 4 screws (L) and the support plate (M) as shown.
CAUTION! Always use the recommended guard for the cutting attachment you are using. See chapter on Technical data.
•Fit the drive disc (B) on the output shaft.
•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.
•Insert the locking pin (C) in the hole to lock the shaft.
•Place the blade (D) on the output shaft.
N
F
D
M
E
B
L
C A
English – 17
