Husqvarna 252RX, 240R, 240F, 265RX, 250R Fitting the blade guard and saw blade, G F D B C, Assembly

ASSEMBLY

•Fit the support flange (F) on the output shaft. Make sure that the blade is centered by fitting it to the guide on the support flange.

•Screw the support cup (E) onto the output shaft threads (CAUTION! Left-hand thread). Tighten to a torque of 35- 50 Nm (3.5-5.0 kpm). Use the socket spanner in the tool kit. Note that the locking pin (C) must remain inside the gear housing to lock the drive disk. Hold the shaft of the socket spanner as close to the blade guard/combination guard as possible.

WARNING! Tighten the lock screw (N) in the

!center hole of the support cup. Tighten to a torque of 35-50 Nm (3.5-5.0 kpm), CAUTION! Left-hand thread. If the lock screw is not fitted in the support cup, there is a risk that the support cup will come unscrewed. This means that the blade will also come loose, which could result in serious or fatal injury to the operator or others.

Fitting the blade guard and saw blade

•The blade guard (A) is fitted using 4 screws (L) as shown.

CAUTION!

Always use the recommended guard for the cutting attachment you are using. See chapter on Technical data.

L

To tighten the nut, turn the spanner in the opposite direction to the direction of rotation (Caution! left-hand thread).

G F

D

B

C

When loosening and tightening the saw blade nut, there is a risk of injury from the teeth of the saw blade. You should therefore always ensure that your hand is shielded by the blade guard when doing this. Always use a socket spanner with a shaft that is long enough to allow this. The arrow in the diagram shows the area where you should operate the socket spanner when loosening or tightening the nut.

Fitting the trimmer guard and trimmer head Trimmy SII

•Fit the correct trimmer guard (A) for use with the trimmer head. Secure the trimmer guard using the 4 screws (L) and the support plate (M) as shown.

•Fit the drive disc (B) on the output shaft.

•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.

•Insert the locking pin (C) in the hole to lock the shaft.

A

• Fit the drive disc (B) on the output shaft.

A

M

L B

C

• Turn the blade shaft until one of the holes in the drive disc

aligns with the corresponding hole in the gear housing.

• Insert the locking pin (C) in the hole to lock the shaft.

• Place the blade (D) and support flange (F) on the output

shaft.

• Fit the nut (G). Tighten the nut to a torque of 35-50 Nm.

Use the socket spanner in the tool kit. Grasp the handle of

the spanner as close to the blade guard/combination

guard as possible.

•Screw on the trimmer head/plastic blades (H) in the opposite direction to the direction of rotation.

•Tighten the trimmer head to a torque of 35-50 Nm.

H

•To dismantle, follow the instructions in the reverse order.

18 – English