What is WHAT?, What is what on the chain saw?

WHAT IS WHAT?

What is what on the chain saw?

1Cylinder cover

2Front handle

3Front hand guard

4Starter

5Chain oil tank

6Starter handle

7Adjuster screws carburettor

8Choke control

9Rear handle

10Stop switch (Ignition on/off switch.)

11Fuel tank

12Mufﬂer

13Bar tip sprocket

14Chain

15Bar

16Spike bumper

17Chain catcher (Catches chain if it jumps or breaks.)

18Clutch cover with built-in chain brake.

19Right hand guard (Protects right hand if chain breaks or jumps.)

20Throttle control

21Throttle lockout (Prevents accidental operation of throttle control.)

22Decompression valve

23Combination spanner

24Chain tensioning screw

25Operator′s manual

26Bar guard

27Air ﬁlter cover

28Lever for extra chain oil.

29Half throttle lock button.

30Product and serial number plate

31Information and warning decal

English – 5

Page 5

Image 5

Husqvarna 3120XP manual What is WHAT?, What is what on the chain saw?

Contents

3120XP Symbols in the operator’s manual KEY to SymbolsSymbols on the machine Contents Dear Customer Introduction What is what on the chain saw? What is WHAT? Always use common sense General Safety PrecautionsBefore using a new chain saw Chain brake and front hand guard Machine′s safety equipmentPersonal protective equipment General Safety Precautions Chain catcher Throttle lockoutRight hand guard Vibration damping system Cutting equipment Stop switchMufﬂer General rules Sharpening your chain and adjusting depth gauge setting Too large Increased if the depth gauge setting isAdjustment of depth gauge setting Lubricating cutting equipment Tensioning the chainWhich could lead to serious, even fatal Chain oil Chain drive sprocket Checking chain lubricationNeedle bearing lubrication Checking wear on cutting equipment Bar Working with the chain AssemblyFitting the bar and chain Fuel Fuel Handling Extra chain oil Fuel safetyFuelling Long-term storage Transport and storage Starting and stopping Starting and StoppingCold engine Warm engine Stopping Working Techniques Basic safety rulesBefore use General working instructions Working Techniques Terms Basic cutting techniqueThere are ﬁve important factors you should consider Limbing Felling direction Tree felling techniqueSafe distance Felling cut Clearing the trunk and preparing your retreatFelling Training we advise you not to fell trees Your saw Freeing a tree that has fallen badly General adviceFreeing a trapped tree Cutting trees and branches that are in tension Cutting the trunk into logs How to avoid kickbackWhat is kickback? Carburettor Maintenance High speed jet H Correctly adjusted carburettor Immediately Checking the brake trigger Changing a broken or worn starter cord MufﬂerStarter Fitting the starter Tensioning the recoil springChanging a broken recoil spring Spark plug Air ﬁlterLubricating the bar tip sprocket Must always be replaced Cooling system Adjustment of the oil pumpNeedle bearing lubrication Daily maintenance Weekly maintenance Monthly maintenance Maintenance schedule Technical data Technical Data Saw chain ﬁling and ﬁle gauges Guide bar and saw chain combinations Applies to Europe only EC-declaration of conformityEN ISO 121002010, ISO 149822009, EN ISO 0404/09/2119 Original instructions 1153183-26