STARTING AND STOPPING
Starting and stopping
WARNING! Note the following before
!starting:
Never start a chain saw unless the bar, chain and all covers are fitted correctly. Otherwise the clutch can come loose and cause personal injuries.
Always move the machine away from the refuelling area before starting.
Place the machine on firm ground. Make sure you have a secure footing and that the chain cannot touch anything.
Keep people and animals well away from the working area.
Cold engine
Starting: The chain brake should be activated when starting the chain saw. Activate the chain brake by pushing the front hand guard forwards.
Ignition: Slide the ignition switch to the left.
Choke: Set the choke control in the choke position.
Start throttle: Press the throttle lock (1). Open throttle fully
(2). Press in button (3).
If the machine is fitted with a decompression valve (A): Press the valve to reduce the pressure in the cylinder and make starting easier. You should always use the decompression valve when starting the machine. Once the machine has started the valve will automatically return to its original setting.
Warm engine
Use the same starting procedure as for a cold engine but without setting the choke control in the choke position.
Starting
Grip the front handle with your left hand. Hold the chain saw on the ground by placing your right foot through the rear handle. Pull the starter handle with your right hand and pull out the starter cord slowly until you feel a resistance (as the starter pawls engage) then pull firmly and rapidly. Never wrap the starter cord around your hand
As the chain brake is still activated the engine must return to idling speed as soon as possible by disengaging the throttel latch in order to avoid unnecessery wear on the clutch assembly.
Push in the choke control as soon as the engine fire and make repeated starting attempts. Immediately press and release the throttle when the engine starts. That will disengage the throttle latch.
English – 27
