Husqvarna 324L, 324LD manual Contents

CONTENTS

Contents
KEY TO SYMBOLS
Symbols	2
CONTENTS
Contents	3
Note the following before starting:	3
INTRODUCTION
Dear customer!	4
WHAT IS WHAT?
What is what?	5
GENERAL SAFETY PRECAUTIONS
Important	6
Personal protective equipment	6
Machine′s safety equipment	7
Cutting equipment	9
ASSEMBLY
Fitting the loop handle	10
Assembling and dismantling the two-piece shaft
(324LDx)	10
Assembling the cutting equipment	10
FUEL HANDLING
Fuel handling	12
Fuel	12
STARTING AND STOPPING
Check before starting	14
Starting and stopping	14
WORKING TECHNIQUES
General working instructions	16
MAINTENANCE
Carburetor	18
Muffler	18
Cooling system	19
Spark plug	19
Two-piece shaft	19
Air filter	19
Maintenance schedule	21
TECHNICAL DATA
Technical data	22
FEDERAL AND CALIFORNIA EMISSIONS
CONTROL WARRANTY STATEMENT
YOUR WARRANTY RIGHTS AND OBLIGATIONS	24

Note the following before starting:

Please read the operator’s manual carefully.

Maintenance, replacement, or repair of the emission control devices and system may be performed by any nonroad engine repair establishment or individual.

WARNING! Long-term exposure to noise can

!result in permanent hearing impairment. So always use approved hearing protection.

WARNING! Under no circumstances may the

!design of the machine be modified without the permission of the manufacturer. Always use genuine accessories. Non-authorized modifications and/or accessories can result in serious personal injury or the death of the operator or others.

Your warranty may not cover damage or liability caused by the use of non-authorized accessories or replacement parts.

WARNING! A clearing saw, brushcutter or

!trimmer can be dangerous if used incorrectly or carelessly, and can cause serious or fatal injury to the operator or others. It is extremely important that you read and understand the contents of this operator’s manual.

This label certifies that the product has been certified in accordance with American exhaust requirements EPA 2.

This engine label certifies that the product is certified in accordance with American exhaust emissions requirements EPA Ph II and Californian exhaust and evaporative emissions requirements CARB Tier III. The Emissions Compliance Period referred to on the emissions compliance label indicates the number of operating hours for which the engine has shown to meet Federal and Californian emission requirements.

Category C = 50 hours, B = 125 hours, and A = 300 hours.

English – 3