Husqvarna 325P5X manual Fitting the impact guard 325P5, Assembly of the saw attachment 325P5

ASSEMBLY

•Tighten the knob.

Dismantling:

Undo the knob (at least three turns).

•Push the knob towards the coupling.

•Carefully twist the upper shaft to unlock it.

•Hold both parts of the shaft and pull the upper shaft out of the coupling.

Fitting the impact guard (325P5)

If the machine has a protective guard bolted under the engine this should be removed before the impact guard is assembled.

Fit the guard using the three screws and washers. Fit the two short screws in hole A. Tighten the screws to a torque of 4 Nm. After the machine has been in use for around 20 hours, re-tighten the screws to 4 Nm.

Assembly of the saw attachment (325P5)

Assembly

•Make sure the knob is loose.

•Align the cut-out in the upper shaft with the coupling's lock plate on the lower shaft. The parts then lock together.

•Tighten the knob.

Dismantling

•Undo the knob (at least three turns).

•Push the knob towards the coupling.

•Carefully twist the upper shaft to unlock it.

•Hold both parts of the shaft and pull the upper shaft out of the coupling.

English – 15