MAINTENANCE
Final setting of the idling speed T
Adjust the idling speed with the screw T, if it is necessary to re- adjust. First turn the idle speed adjusting screw T clockwise until the cutting attachment starts to rotate/move.
Then turn,
CAUTION! Contact your ser- vicing dealer, if the idle speed setting cannot be adjusted so that the cutting attachment stops. Do not use the machine until it has been properly ad- justed or repaired.
High speed needle H
Correctly adjusted carburetor
A correctly adjusted carburetor means that the machine ac- celerates without hesitation and the machine
A too lean adjusted high speed needle H gives lower power = less capacity, bad acceleration and/or damage to the engine. A too rich adjustment of the two speed needles L and H gives acceleration problems or too low working speed.
The high speed needle H
influences the power, speed, temperature and fuel con- sumption of the machine. A too lean adjusted high speed needle H (high speed needle H closed too much) gives over- revs and damages the engine. Do not let the machine run at full speed for more than 10 seconds.
Turn the high speed needle very slowly clockwise until engine speed is reduced. Thereafter turn the high speed needle very slowly counter- clockwise and stop when the engine begins to run roughly. Then turn the high speed needle slowly the minimum amount clockwise until the engine runs smoothly.
The high speed needle H is correctly set when the ma- chine
H |
NOTE! For optimum setting of the carburetor, contact a qualified servicing dealer who has a revolution counter at his disposal.
English – 17
