Husqvarna 326L Assembly, Fitting the loop handle, Assembling and dismantling the two-piece shaft

ASSEMBLY

Fitting the loop handle

(326C)

•Position the handle on the shaft. Note that the handle must be mounted below the arrow on the shaft.

•Fit the screw, securing plate and wing nut as shown in the diagram.

•Tighten the wing nut.

Fitting the loop handle

(326L, 326Lx, 326LDx)

•Clip the loop handle onto the shaft. Note that the loop handle must be fitted between the arrows on the shaft.

•Slide the spacer into the slot in the loop handle.

•326L: Fit the nut, washer and screw.

326LX/326LDX: Fit the nut, knob and screw. Do not overtighten.

•Now adjust the trimmer to give a comfortable working position. Tighten the bolt/knob.

Assembling and dismantling the two-piece shaft

(326LDx)

Assembly:

•Make sure the knob is loose.

•Align the cut-out in the lower part of the shaft with the coupling locking tab on the upper part of the shaft. Then lock the sections together.

•Tighten the knob.

Dismantling:

•Undo the knob (at least three turns).

•Push the knob towards the coupling.

•Carefully twist the lower half of the shaft to unlock it.

•Hold both parts of the shaft and pull the lower part of the shaft out of the coupling.

Fitting the trimmer head

When fitting the cutting attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury.

WARNING! Never use a cutting attachment

!without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury.

12 – English