MAINTENANCE
the excess before fitting the filter to the machine. Never use common engine oil. This would drain through the filter quite quickly and collect in the bottom.
Bevel gear
(326L, 326Lx, 326LDx)
The bevel gear is filled with the right quantity of grease at the factory. However, before using the machine you should check that the bevel gear is filled
The grease in the bevel gear does not normally need to be changed except if repairs are carried out.
CAUTION! Use only HUSQVARNA replacement parts. Use of other brands of replacement parts can cause damage to your unit or injury to the operator or others. Your warranty does not cover damage or liability caused by the use of accessories and/or attachments not specifically recommended by HUSQVARNA.
Maintenance schedule
Below you will find some general maintenance instructions.
Daily maintenance
•Check throttle trigger and throttle trigger lockout function.
•Check that the stop switch works correctly.
•Check that there are no fuel leaks from the engine, tank or fuel lines.
•Check that the cutter does not rotate when the engine is idling.
•Clean the outside of the machine.
•Check that the harness is not damaged.
•Check that the blade guard is not damaged or cracked. Replace the blade guard if it is exposed to impact or is cracked.
•A
•Check that nuts and screws are tight.
•Check that the screws that hold the bevel gear are tight.
Weekly maintenance
•Check the starter and starter cord.
•Clean the carburettor area.
•Clean the outside of the spark plug. Remove it and check the electrode gap. Adjust the gap to 0.5 mm (.20”), or replace the spark plug. Check that the spark plug is fitted with a suppressor.
•Clean the cooling fins on the cylinder and check that the air intake near the starter is not blocked.
•Check that the bevel gear is filled with grease up to 3/4. Use special grease.
•Clean the air filter.
Monthly maintenance
•Clean the fuel tank.
•Clean the outside of the carburettor and the space around it.
•Clean the fan and the area around it.
•Check fuel hose for cracks or other damage. Change if necessary.
•Change the fuel filter in fuel tank.
•Check the clutch, clutch springs and the clutch drum for wear. Replace if necessary.
•Check electrical wires and connections.
•Replace the spark plug. Check that the spark plug is fitted with a suppressor.
•Change the air filter.
•Check and clean the spark arrestor mesh on the muffler (only applies to mufflers fitted with a catalytic converter).
English – 21
