SAFETY INSTRUCTIONS
Checking chain lubrication
•Check the chain lubrication each time you refuel.
Aim the tip of the bar at a light coloured surface about 20 cm (8 inches) away. After 1 minute running at 3/4 throttle you should see a distinct line of oil on the light surface.
If the chain lubrication is not working:
•Check that the oil channel in the bar is not obstructed. Clean if necessary.
•Check that the groove in the edge of the bar is clean. Clean if necessary.
•Check that the bar tip sprocket turns freely and that the lubricating hole in the tip sprocket is not blocked. Clean and lubricate if necessary.
If the chain lubrication system is still not working after carrying out the above checks and associated measures you should contact your service agent.
Lubricating the bar tip sprocket
Lubricate the bar tip sprocket each time you refuel. Use the special grease gun and a good quality bearing grease.
Needle bearing lubrication
The clutch drum is fitted with one of the following drive sprockets:
ASpur sprocket (the chain sprocket is welded on the drum)
BRim sprocket (replaceable)
Both versions have a needle bearing on the drive shaft, which has to be greased regularly (once a week). CAUTION! Use only high quality bearing grease or engine oil.
Checking wear on cutting equipment
Check the chain daily for:
•Visible cracks in rivets and links.
•Whether the chain is stiff.
•Whether rivets and links are badly worn.
We recommend you compare the existing chain with a new chain to decide how badly the existing chain is worn.
When the length of the cutting teeth has worn down to only 4 mm the chain must be replaced.
Chain drive sprocket
The clutch drum is fitted with one of the following drive sprockets:
ASpur sprocket (the chain sprocket is welded on the drum)
BRim sprocket (replaceable)
Regularly check the degree of wear on the drive sprocket. Replace if wear is excessive. Replace the drive sprocket whenever you replace the chain.
14 – English
