Husqvarna 525 RJD manual Fitting a blade guard, grass blade and grass cutter, Dismantling, G F E D

ASSEMBLY

Dismantling

•Loosen the coupling by turning the knob (at least 3 times).

Push and hold the button (C). While securely holding the engine end, pull the attachment straight out of the coupling.

C

Fitting a blade guard, grass blade and grass cutter

G

F

E

D

A B

C

•Hook the blade guard/combination guard (A) onto the fitting on the shaft and secure with the bolt.

CAUTION! Use the recommended blade guard. See the Technical data section.

•Fit the drive disc (B) on the output shaft.

•Turn the output shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.

•Insert the locking pin (C) in the hole to lock the shaft.

•Place the blade (D), support cup (E) and support flange (F) on the output shaft.

•Fit the nut (G). The nut must be tightened to a torque of 35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool kit. Hold the shaft of the spanner as close to the blade guard as possible. To tighten the nut, turn the spanner in the opposite direction to the direction of rotation (Caution! left-hand thread).

Adjusting the harness and brush cutter

!	WARNING! When using a brush cutter it
	must always be hooked securely to the
	harness. Otherwise you will be unable to
	control the brush cutter safely and this
	can result in injury to yourself or others.
	Never use a harness with a defective
	quick release.

14 – English