Husqvarna 966781601, 525 RS manual Assembly, Fitting the loop handle 524 L, 525 LST, 525 RJD

ASSEMBLY

Fitting the loop handle (524 L, 525 LST, 525 RJD)

•Clip the loop handle onto the shaft. Note that the loop handle must be fitted between the arrows on the shaft.

•Slide the spacer into the slot in the loop handle. Fit the nut, knob and screw. Do not overtighten.

•Now adjust the trimmer to give a comfortable working position. Tighten the bolt.

Fitting the handlebar (525 RS)

•Remove the screw at the rear of the throttle handle.

•Slide the throttle handle onto the right side of the handlebar, (see diagram).

•Align the screw hole in the throttle handle with the hole in the handlebar.

•Refit the screw in the hole in the rear of the throttle handle.

•Screw the screw through the handle and handlebar. Tighten it.

•Unscrew the knob from the handlebar mounting.

•Position the handlebar as shown. Fit the mounting components and tighten the knob lightly.

•Put on the harness and hang the machine from the support hook. Now make a final adjustment so that the machine is in a comfortable working position when it hangs from the harness.

12 – English