Husqvarna 525RXT Brush cutting with a saw blade, Grass clearing using a grass blade, Trimming

WORKING TECHNIQUES

Brush cutting with a saw blade

•Thin stems and brush are mown down. Work with a sawing movement, swinging sideways.

•Try to cut several stems in a single sawing movement.

•With groups of hardwood stems, first clear around the group. Start by cutting the stems high up around the outside of the group to avoid jamming. Then cut the stems to the required height. Now try to reach in with the blade and cut from the centre of the group. If it is still difficult to gain access, cut the stems high up and let them fall. This will reduce the risk of jamming.

Grass clearing using a grass blade

•Grass blades and grass knifes must not be used on woody stems.

•A grass blade is used for all types of tall or coarse grass.

•The grass is cut down with a sideways, swinging movement, where the movement from right-to-left is the clearing stroke and the movement from left-to- right is the return stroke. Let the left-hand side of the blade (between 8 and 12 o’clock) do the cutting.

•If the blade is angled to the left when clearing grass, the grass will collect in a line, which makes it easier to collect, e.g. by raking.

•Try to work rhythmically. Stand firmly with your feet apart. Move forward after the return stroke and stand firmly again.

•Let the support cup rest lightly against the ground. It is used to protect the blade from hitting the ground.

•Reduce the risk of material wrapping around the blade by following these instructions:

1Always work at full throttle.

2Avoid the previously cut material during the return stroke.

•Stop the engine, unclip the harness and place the machine on the ground before you start to collect the cut material.

Grass trimming with a trimmer head

Trimming

•Hold the trimmer head just above the ground at an angle. It is the end of the cord that does the work. Let the cord work at its own pace. Never press the cord into the area to be cut.

•The cord can easily remove grass and weeds up against walls, fences, trees and borders. However it can also damage sensitive bark on trees and bushes, and damage fence posts.

•Reduce the risk of damaging plants by shortening the cord to 10-12 cm and reducing the engine speed.

Clearing

•The clearing technique removes all unwanted vegetation. Keep the trimmer head just above the ground and tilt it. Let the end of the cord strike the ground around trees, posts, statues and the like. CAUTION! This technique increases the wear on the cord.

•The cord wears quicker and must be fed forward more often when working against stones, brick, concrete, metal fences, etc., than when coming into contact with trees and wooden fences.

English – 23