Installation Instructions
1WINDOW REQUIREMENTS
•These instructions are for a standard
•All supporting parts must be secured to firm wood, masonry or metal..
•The electrical outlet must be within reach of the power cord..
•Follow the dimensions in the table and illustration for your model..
19 1/4”
29” - 41” (With accordion panels)
2STORM WINDOW REQUIREMENTS
A storm window frame will not allow the air conditioner to tilt toward the outside, and will keep it from draining properly..
To adjust for this, attach a piece of wood to the sill..
WOOD PIECES
WIDTH: 2”
LENGTH: Long enough to fit inside the window frame..
THICKNESS: To determine the thickness, place a piece of wood on the sill to make it 1/2″ higher than the top of the storm window frame or the vinyl frame..
Attach securely with nails or screws provided by the installer..
3PREPARE THE AIR CONDITIONER
APull down the front panel and remove the filter.. Remove the front panel by lifting up at an angle..
BRemove the four front screws. Save them for reinstalling the front housing.
CGrasp the lower corners of the grille while pressing in on the case sides with your finger tips. Pull out to release and lift it up.
NOTE: Do not pull the bottom edge toward you more than 3″ or you may damage the tabs of the grille.
D When the front grille is removed the |
control panel will still be attached by |
a harness. Turn the grille around so |
you can see the back side of the grille. |
1/2″ higher than storm window frame
Storm window frame
1/2″ higher than vinyl frame (on some windows)
Wood
Sill
Vinyl frame
Remove the 2 screws to separate the |
control panel housing from the grille. |
NOTE: Be sure to save these screws. You will |
need them later in the installation. |
Remove Screws
9