![](/images/new-backgrounds/1171383/17138327x1.webp)
STORAGE
Immediately prepare your lawn mower for storage at the end of |
|
| ENGINE | ||||
the season or if the unit will not be used for 30 days or more. |
|
|
| ||||
|
|
|
|
|
|
| FUEL SYSTEM |
| CAUTION: Never store the lawn mower |
| |||||
|
|
|
| IMPORTANT: IT IS IMPORTANT TO PREVENT GUM | |||
| with gasoline in the tank inside a building |
|
|
| |||
|
|
|
| DEPOSITS FROM FORMING IN ESSENTIAL FUEL | |||
| where fumes may reach an open flame or |
|
|
| |||
|
|
|
| SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, | |||
| spark. Allow the engine to cool before |
|
|
| FUEL HOSE, OR TANK DURING STORAGE. ALSO, | ||
| storing in any enclosure. |
|
|
| EXPERIENCE INDICATES THAT ALCOHOL BLENDED | ||
|
|
|
|
|
|
| FUELS (CALLED GASOHOL OR USING ETHANOL OR |
LAWN MOWER |
|
| METHANOL) CAN ATTRACT MOISTURE WHICH LEADS | ||||
|
| TO SEPARATION AND FORMATION OF ACIDS DURING | |||||
|
|
|
|
|
|
| STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL |
When lawn mower is to be stored for a period of time, clean it |
|
| SYSTEM OF AN ENGINE WHILE IN STORAGE. | ||||
thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, |
|
| • Drain the fuel tank. | ||||
dry area. |
|
| • Start the engine and let it run until the fuel lines and | ||||
|
|
|
|
|
|
| |
• Clean entire lawn mower (See “CLEANING” in the Cus- |
|
| carburetor are empty. | ||||
| tomer Responsibilities section of this manual). |
|
| • Never use engine or carburetor cleaner products in the | |||
|
|
|
|
|
|
| |
• | Lubricate as shown in the Customer Responsibilities sec- |
|
| fuel tank or permanent damage may occur. | |||
| tion of this manual. |
|
| • Use fresh fuel next season. | |||
• Be sure that all nuts, bolts, screws, and pins are securely |
|
| |||||
|
| NOTE: Fuel stabilizer is an acceptable alternative in | |||||
| fastened. Inspect moving parts for damage, breakage and |
|
| ||||
|
|
| minimizing the formation of fuel gum deposits during stor- | ||||
| wear. Replace if necessary. |
|
| ||||
|
|
| age. Add stabilizer to gasoline in fuel tank or storage | ||||
|
|
|
|
|
|
| |
• Touch up all rusted or chipped paint surfaces; sand lightly |
|
| container. Always follow the mix ratio found on stabilizer | ||||
| before painting. |
|
| container. Run engine at least 10 minutes after adding | |||
HANDLE (SEE FIG. 18) |
|
| stabilizer to allow the stabilizer to reach the carburetor. Do | ||||
|
| not drain the gas tank and carburetor if using fuel stabilizer. | |||||
• You can fold your lawn mower handle for storage. |
|
| ENGINE OIL | ||||
• Loosen the two (2) handle knobs on sides of the upper |
|
| |||||
|
|
| |||||
| handle and allow handle to fold down to the rear. |
|
| Drain oil (with engine warm) and replace with clean oil. | |||
• | Squeezethebottomendsoflowerhandletowardeachother |
|
| (See “ENGINE” in the Customer Responsibilities section | |||
|
| of this manual). | |||||
| until pins in handle clear the brackets and pivot entire handle |
|
| ||||
|
|
|
| ||||
| assembly forward and allow it to rest on mower. |
|
| CYLINDER | |||
• When setting up your handle from the storage position, the |
|
| |||||
|
|
| |||||
| lower handle will require manually locking into the mowing |
|
| • Remove spark plug. | |||
| position. |
|
| • Pour one ounce (29 ml) of oil through spark plug hole | |||
|
|
|
|
|
|
| |
IMPORTANT: WHEN FOLDING THE HANDLE FOR STORAGE OR |
|
| into cylinder. | ||||
TRANSPORTATION,BESURETOFOLDTHEHANDLEASSHOWN |
|
| • Pull starter handle slowly to distribute oil. | ||||
OR YOU MAY DAMAGE THE CONTROL CABLES. |
|
| |||||
|
| • Replace with new spark plug. | |||||
| OPERATOR PRESENCE |
|
| ||||
| CONTROL BAR |
|
|
| |||
| UPPER HANDLE |
|
|
| |||
|
|
|
| ||||
| FOLD FORWARD |
|
| OTHER | |||
| FOR STORAGE |
|
| • Do not store gasoline from one season to another. | |||
|
|
|
|
|
|
| |
|
| FOLD BACKWARD |
|
| • Replace your gasoline can if your can starts to rust. | ||
|
|
|
|
|
|
| Rust and/or dirt in your gasoline will cause problems. |
|
| MOWING |
|
| • If possible, store your unit indoors and cover it to give | ||
|
| POSITION |
|
| protection from dust and dirt. | ||
|
|
|
|
|
|
| • Cover your unit with a suitable protective cover that |
| LOWER HANDLE |
|
| does not retain moisture. Do not use plastic. Plastic | |||
|
|
|
|
|
|
| cannot breathe which allows condensation to form and |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| will cause your unit to rust. |
|
|
|
|
|
|
| IMPORTANT: NEVER COVER MOWER WHILE ENGINE |
|
|
|
|
|
|
| AND EXHAUST AREAS ARE STILL WARM. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| CAUTION: Never store the lawn mower |
|
|
|
|
|
|
| with gasoline in the tank inside a build- |
|
|
|
|
|
|
| ing where fumes may reach an open |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| flame or spark. Allow the engine to |
|
|
|
|
|
|
| cool before storing in any enclosure. |
|
|
|
|
|
|
|
|
FIG. 18
14