Mufﬂer, Chain catcher | Husqvarna 576XP AutoTune instruction

MAINTENANCE

Chain catcher

Check that the chain catcher is not damaged and is ﬁrmly attached to the body of the chain saw.

Right hand guard

Check that the right hand guard is not damaged and that there are no visible defects, such as cracks.

Vibration damping system

Regularly check the vibration damping units for cracks or deformation.

Make sure the vibration damping units are securely attached to the engine unit and handle unit.

Stop switch

Start the engine and make sure the engine stops when you move the stop switch to the stop setting.

Mufﬂer

Never use a machine that has a faulty mufﬂer.

Regularly check that the mufﬂer is securely attached to the machine.

Some mufﬂers are equipped with a special spark arrestor screen. If your machine has this type of mufﬂer, you should clean the screen at least once a week. This is best done with a wire brush. A blocked screen will cause the engine to overheat and may lead to serious damage.

Note! The screen must be replaced if it is damaged. If the screen is blocked the machine will overheat and this will cause damage to the cylinder and piston. Never use a machine with a mufﬂer that is in poor condition. Never

English – 31

Image 31

Husqvarna 576XP AutoTune manual Mufﬂer, Chain catcher

Contents

576XP AutoTune You will ﬁnd the following labels on your chain saw KEY to SymbolsSymbols on the machine Symbols in the operator’s manual Contents Dear customer Introduction What is what on the chain saw? What is WHAT? Before using a new chain saw General Safety Precautions Chain brake and front hand guard Machine′s safety equipmentAlways use common sense Personal protective equipment General Safety Precautions Chain catcher Throttle lockoutRight hand guard Mufﬂer Stop switchCutting equipment Vibration damping system Bar Cutting equipment designed to reduce kickbackChain General information on sharpening cutting teeth Sharpening your chain and adjusting depth gauge setting Tensioning the chain Filling with chain oil Lubricating cutting equipmentChecking chain lubrication Needle bearing lubrication Chain drive sprocketChecking wear on cutting equipment Fitting the bar and chain AssemblyWorking with the chain Fuel Fuel Handling Long-term storage Fuel safetyFueling Transport and storage Warm engine Starting and StoppingStarting and stopping Cold engine Stopping General working instructions Basic safety rulesWorking Techniques Before use General rules Terms Basic cutting technique Limbing Clearing the trunk and preparing your retreat Tree felling techniqueSafe distance Felling direction Felling cut Directional cuts Cutting trees and branches that are in tension General adviceFreeing a tree that has fallen badly Freeing a trapped tree What is kickback? How to avoid kickbackCutting the trunk into logs Carburetor adjustment MaintenanceGeneral Immediately Checking the inertia brake release Mufﬂer Changing a broken recoil spring StarterChanging a broken or worn starter cord Tensioning the recoil spring Fitting the starter Air ﬁlterSpark plug Lubricating the bar tip sprocket Needle bearing lubrication Adjustment of the oil pumpAir Injection centrifugal cleaning When making adjustments Fitting the winterising kit Temperature 0C 32F or colderTemperature -5C 23F or colder Winter use Daily maintenance Weekly maintenance Monthly maintenance Maintenance schedule Technical data Technical Data With signiﬁcantly reduced kickback potential are available Saw chain ﬁling and ﬁle gauges Your Warranty Rights and Obligations Federal Emission Control Warranty Statement Other safety precautions American Standard Safety PrecautionsSafety precautions for chain saw users Kickback safety precautionsPage ´z+S==¶5\¨ Page 1151292-95