Husqvarna 65021CHV How To Use Your Lawn Mower, Engine Speed, Engine Zone Control, Operation

OPERATION

The operation of any lawn mower can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your lawn mower or per- forming any adjustments or repairs. We recommend standard safety glasses or a wide vision safety mask over spectacles.

HOW TO USE YOUR LAWN MOWER

ENGINE SPEED

The engine speed was set at the factory for optimum per- formance. Speed is not adjustable.

ENGINE ZONE CONTROL

CAUTION: Federal regulations require an engine control to be installed on this lawn mower in order to minimize the risk of blade contact injury. Do not under any circumstances attempt to defeat the function of the operator control. The blade turns when the engine is running.

•Your lawn mower is equipped with an operator presence control bar which requires the operator to be positioned behind the mower handle to start and operate the mower.

1.Turn unit off and disconnect spark plug wire from plug.

2.Turn nut on underside of drive control to increase drive speed.

3.Operatemowertotestdrivespeed. Readjustasrequired.

4.If condition fails to improve after the above steps (for- ward speed remains the same), your drive belt is worn and should be replaced.

TO ADJUST CUTTING HEIGHT (See Fig. 4)

Raise wheels for low cut and lower wheels for high cut, adjust cutting height to suit your requirements. Medium position is best for most lawns.

•To change cutting height, squeeze adjuster lever toward wheel. Move wheel up or down to suit your requirements. Be sure all wheels are in the same setting.

NOTE: Adjuster is properly positioned when plate tab inserts into hole in lever. Also, 9-position adjusters (if so equipped) allow lever to be positioned between the plate tabs.

DRIVE CONTROL (See Fig. 3)

• Self-propelling is controlled by holding the operator

presence control bar down to the handle and pulling

LEVER BACKWARD TO LOWER MOWER

the drive control lever rearward to the handle. The

farther toward the handle the lever is pulled, the faster

the unit will travel.

• Forward motion will stop when either the operator pres-

ence control bar or drive control lever are released. To

stop forward motion without stopping engine, release

the drive control lever only. Hold operator presence

control bar down against handle to continue mowing

without self-propelling.

NOTE: If after releasing the drive control the mower will not roll backwards, push the mower forward slightly to disengage drive wheels.

PLATE

TAB

LEVER FORWARD TO RAISE MOWER

FIG. 4

TO CONVERT MOWER

LEVER

•To keep drive control engaged when turning corners, push down on the handle to lift the front wheels off the ground while turning lawn mower.

OPERATOR PRESENCE CONTROL BAR
		DRIVE
		CONTROL
	TO	LEVER
ADJUSTMENT	ENGAGE	DRIVE
TURNBUCKLE	DRIVE	CONTROL
(ON UNDERSIDE)	CONTROL	DISENGAGED

FIG. 3

Your lawn mower was shipped ready to be used as a mulcher. To convert to bagging or discharging:

REAR BAGGING (See Fig. 5)

•Lift rear door of the lawn mower and place the grass catcher frame hooks onto the door pivot pins.

•To convert to mulching or discharging operation, remove grass catcher and close rear door.

REAR

DOORGRASS

CATCHER

HANDLE

DRIVE CONTROL ADJUSTMENT (See Fig. 3)

Over time, the drive control system may become “loose”,		PIVOT PINS
resulting in decreased speed. There is a turnbuckle on the		CATCHER FRAME HOOK
underside of the drive control housing to increase tension
	6
on the drive cable. Proceed as follows:		FIG. 5