SERVICE AND ADJUSTMENTS
CAUTION: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
1.Release control bar and stop engine.
2.Make sure the blade and all moving parts have completely stopped.
3.Disconnect spark plug wire from spark plug and place where it cannot come in contact with plug.
LAWN MOWER
TO ADJUST CUTTING HEIGHT
See “TO ADJUST CUTTING HEIGHT” in the Operation section of this manual.
REAR DEFLECTOR
The rear defl ector, attached between the rear wheels of your mower, is provided to minimize the possibility that objects will be thrown out of the rear of the mower into the operator's mowing position. If the defl ector becomes damaged, it should be replaced.
TO REMOVE DRIVE BELT (See Fig. 13)
1.Remove drive cover. Remove belt from gearcase pulley by pushing down on pulley and rolling belt off it.
2.Turn mower on its side (air fi lter and carburetor up).
3.Remove blade.
4.Remove debris shield.
5.Remove belt from engine pulley on crankshaft. Replace drive belt by reversing above steps.
NOTE: Always use factory approved belt to assure fi t and long life.
DRIVE BELT
COVER
SQUEEZE |
|
TO ADJUST |
|
LOWER HANDLE | |
MOUNTING PIN | |
HANDLE | HAIRPIN |
BRACKET | COTTER |
FIG. 14
MOWING | MOWING |
POSITION | POSITION |
HAIRPIN |
|
COTTER | HANDLE |
| |
MOUNTING | BRACKET |
PIN |
|
LOW POSITION | HIGH POSITION |
FIG. 15
LOWER
HANDLE
ROTATE
PUSH DOWN
ENGINE
FIG. 16
FIG. 13
TO ADJUST HANDLE (See Figs. 14 thru 16)
The handle can be mounted in a high or low position. The mounting holes in the bottom of lower handle are off center for raising or lowering the handle.
1.Remove upper handle and all wire tie(s) securing cable(s) to lower handle.
2.Remove hairpin cotters from lower handle bracket mounting pin.
3.Squeeze lower handle in to remove from mounting pins.
4.Turn lower handle over to raise or lower handle.
5.Squeeze lower handle in and position holes onto mounting pins on handle bracket.
6.Reassemble upper handle and all parts removed from
lower handle. | 12 |
ENGINE SPEED
Your engine speed has been factory set. Do not attempt to increase engine speed or it may result in personal injury. If you believe that the engine is running too fast or too slow, take your lawn mower to an authorized service center for repair and adjustment.
CARBURETOR
Your carburetor is not adjustable. If your engine does not operate properly due to suspected carburetor problems, take your lawn mower to an authorized service center for repair and/or adjustment.
IMPORTANT:NEVERTAMPERWITHTHEENGINEGOVERNOR, WHICH IS FACTORY SET FOR PROPER ENGINE SPEED. OVERSPEEDING THE ENGINE ABOVE THE FACTORY HIGH SPEED SETTING CAN BE DANGEROUS. IF YOU THINK THE
