![](/images/new-backgrounds/1195928/1959285x1.webp)
•Do not put hands or feet near or under rotating parts. Keep clear of the discharge opening and front auger area at all times.
•Exercise extreme caution when operating on or cross- ing gravel drives, walks or roads. Stay alert for hidden hazards or traffic.
•After striking a foreign object, stop the engine (motor), remove wire from the spark plug, thoroughly inspect snow thrower for any damage, and repair the damage before restarting and operating the snow thrower.
•If the unit should start to vibrate abnormally, stop the engine (motor) and check immediately for the cause. Vibration is generally a warning of trouble.
•Stop the engine (motor) whenever you leave the oper- ating position, before unclogging the auger/impeller housing or discharge chute and when making any repairs, adjustments, or inspections.
•When cleaning, repairing, or inspecting, make certain all controls are disengaged and the auger/impeller and all moving parts have stopped. Disconnect the spark plug wire and keep the wire away from the spark plug to prevent accidental starting.
•Take all possible precautions when leaving the snow thrower unattended.Disengage the auger/impeller, stop engine (motor), and remove key.
•Do not run the engine (motor) indoors, except when starting the engine (motor) and for transporting the snow thrower in or out of the building. Open the outside doors.
WARNING: Exhaust fumes are dan- gerous (containing CARBON MONOX- IDE, an ODORLESS and DEADLY GAS).
•Do not clear snow across the face of slopes. Exercise extreme caution when changing direction on slopes. Do not attempt to clear steep slopes.
•Never operate the snow thrower without proper guards, plates or other safety protective devices in place.
•Never operate the snow thrower near glass enclo- sures, automobiles, window wells,
•Do not overload the machine capacity by attempting to clear snow at too fast a rate.
•Never operate the machine at high transport speeds on slippery surfaces. Look behind and use care when backing up.
•Never direct discharge at bystanders or allow anyone in front of the unit.
•Disengage power to the auger/impeller when snow thrower is transported or not in use.
•Use only attachments and accessories approved by the manufacturer of the snow thrower (such as wheel weights, counterweights, cabs, tire chains, electric start kits, etc.).
•Never operate the snow thrower without good visibility or light. Always be sure of your footing and keep a fi rm hold on the handles. Walk; never run.
•Do not overreach. Keep proper footing and balance at all times.
•This snow thrower is for use on sidewalks, driveways and other ground level surfaces.
•Do not use the snow thrower on surfaces above ground level such as roofs of residences, garages, porches or other such structures or buildings.
MAINTENANCE AND STORAGE
•Check shear bolts and other bolts at frequent intervals for proper tightness to be sure the equipment is in safe working condition.
•Never store the snow thrower with fuel in the tank inside a building where ignition sources are present such as hot water and space heaters, clothes dryers, and the like. Allow the engine (motor) to cool before storing in any enclosure.
•Always refer to operator’s guide instructions for im- portant details if the snow thrower is to be stored for an extended period.
•Maintain or replace safety and instruction labels, as necessary.
•Run the snow thrower, with auger engaged, a few minutes after throwing snow to clear the machine and prevent
CONGRATULATIONS on your purchase of a new snow thrower. It has been designed, engineered and manufactured to give best possible dependability and performance.
Should you experience any problem you cannot easily remedy, please contact your nearest authorized service center/department. We have competent,
Please read and retain this manual. The instructions will enable you to assemble and maintain your snow thrower properly. Always observe the “SAFETY RULES”.
SERIAL NUMBER: ___________________________
DATE OF PURCHASE: _______________________
THE MODEL AND SERIAL NUMBERSWILL BE FOUND ON A DECAL ATTACHEDTOTHE REAR OFTHE SNOW THROWER HOUSING.
YOU SHOULD RECORD BOTH SERIAL NUMBER AND DATE OF PURCHASE AND KEEP IN A SAFE PLACE
FOR FUTURE REFERENCE.
3
PRODUCT SPECIFICATIONS
Gasoline Capacity | 4.0 Quarts |
and Type: | Unleaded Regular only |
|
|
Oil Type | SAE 30 (above 40°F) |
| SAE |
| SAE |
|
|
Oil Capacity: | 26 Ounces |
|
|
Spark Plug: | Champion RN4C (Gap: .030") |
|
|
CUSTOMER RESPONSIBILITIES
•Read and observe the safety rules.
•Follow a regular schedule in maintaining, caring for and using your snow thrower.
•Follow the instructions under “Maintenance” and “Stor- age” sections of this owner’s manual.