Graco 3A2098H Operate Swirl Dispenser From Maintenance Screen, Manually Dispense Fluid

Operation

4.Press to move to the target fields. Enter the tar- get pressure, flow rate, or volume (dependent on

control mode) and press to save.

5.Press to move to the valve check boxes. Press

to select the desired valves.

6.Follow step 2 - 4 of Manually Dispense Fluid, page 44.

Manually Dispense Fluid

1.From Fluid Plate x, screen 1, press to enter maintenance screen.

2.Press and verify that the valve opens.

3.Continue to press as long as needed to load or dispense material.

4.Press again to exit maintenance screen.

Operate Swirl Dispenser From Maintenance Screen

1.Navigate to the Swirl x screen for the desired Swirl Dispenser. If the Swirl Dispenser is installed on Fluid Plate x, you may also navigate to Fluid Plate x, screen 1.

FIG. 32

2. Press to enter maintenance screen.

FIG. 33

3.To change the RPM, use the arrow keys to navigate to the RPM box then enter the desired RPM.

4.Press and verify that the Swirl Dispenser

begins rotating. Press again to stop the Swirl Dispenser.

5.Press again to exit maintenance screen.

44 3A2098H