Graco 3A2098H Automation Gateway Setup Screens, Gateway Setup Screen 1 DeviceNet

Appendix A - Advanced Display Module (ADM)

Automation Gateway Setup Screens

There are up to three automation Gateway Setup screens (depending on fieldbus), which enable users to set or change information regarding the automation Gateway module used on the PCF system. These screens also enable users to view information regarding the particular automation Gateway module used.

Press to scroll through the Gateway Setup screens. Once in the desired Advanced Setup screen,

pressto access the fields to make changes. Press to exit edit mode.

NOTE: Users must be out of edit mode to scroll through the Gateway Setup screens.

Gateway Setup Screen 1 - DeviceNet

This screen enables users to set the device address and the baud rate. The DeviceNet screen displays the hard- ware revision number, system serial number, map ID, name, revision number, and install date.

Gateway Setup Screen 1 - EtherNet/IP

This screen enables users to set the IP address, subnet mask, Gateway, DNS 1, DNS 2, and if a DHCP is used.

Gateway Setup Screen 2 - EtherNet/IP

This screen is the same for EtherNet/IP and PROFI- BUS. It enables users to view the following information regarding the Gateway module used on the PCF sys- tem:

•hardware revision number

•system serial number

•map ID number

•map name

•map revision number

•date the map was created

102 3A2098H