Graco 3A2098H important safety instructions Configure Control Settings

Configure Control Settings

Set the controls for the dispense source, how dispense commands are sent, and job settings.

1.With the system in setup mode, navigate to Fluid Plate x, screen 1 (Control Settings).

2.Press to access the fields to make changes.

FIG. 20

3.Press to open the Dispense Trigger Source drop-down list, and select Gateway, Command Cable, Command Cable 3x, or Combined. If Com- mand Cable is selected, users can enable the

valves. Press to finalize the selection.

4.If the dispense trigger source is set to Command

Cable, press to move to the Enable Valves field.

Press and to enable valves.

5.Press to move to the Command Value Source

field. Press to open the drop-down list, and select Gateway, Command Cable, or Display. Press to enter the value.

6.Press to move to the Job End Mode field. Press

to open the drop-down list, and select Timer or

Gateway. Press to enter the value.

System Setup

7.Press to move to the Job End Delay field. Enter

the desired delay time (in seconds). Press to enter the value.

8.Press to move to the Run Mode Bead Adjust

field. Press to open the drop-down list, and

select Enable or Disable. Press to enter the value.

9.Press to move to the End Job on Alarm Check-

box. Press to enable or disable.

10.Press to move to the Display Control Password

field. Press to enter the value.

11.Press to exit edit mode.

12.If multiple fluid plates are installed, repeat this pro- cedure for the other Fluid Plates.

3A2098H 33