Graco 3A2098H important safety instructions Wfd, Wfg, Ejd, Wxd

						Errors
Event	Gateway		Event
Code	Error No.	Event Name	Description	Event Type	Cause	Solution
			Fluid Plate Events and Errors
V2D_	62	Low Analog	Command cable analog	Deviation	Bad or loose com-	Check command cable
			command dropped		mand cable connec-	and connection
			below minimum value		tion
			of 1 V while dispensing
					Entered command	Enter correct com-
					mode incorrectly	mand code
					Automation program	Verify correct automa-
					error	tion program
WFD_	63	Flow Meter	Operating mode	Alarm or	Selected valve mode	Check valve mode set-
WFG_		Required	requires flow meter.	Advisory	settings require flow	tings
			Advisory is issued if	(self-clearing)	meter	Purchase meter
			fluid plate settings
			require a flow meter but			enabled token for FCM
			meter is not present.			and install flow meter
			Alarm is issued if dis-		FCM key token miss-	Check for FCM key
			pense is attempted in		ing or invalid	token error
			mode that requires a
			flow meter but meter is
			not present.
EJD_	64	Job Cycle Time	Job cycle time out	Alarm	Automation signals did	Check automation pro-
		Out			not properly end job	gramming per job oper-
					cycle	ating instruction
WXD_	65	Fluid Plate Error	Fluid plate error	Alarm	Analog voltage applied	Limit signal on pin 1 of
		Detected	detected; includes any		to pin 1 of the com-	command cable to the
			error not covered by		mand cable exceeds	range of 0-10 Vdc.
			another more specific		10 Vdc.
			error
					Failed FCM	Replace FCM if neces-
						sary
P3F_	66	Maximum Inlet	Inlet pressure to regula-	Alarm or	Incorrect set limit	Verify limit is set cor-
P4F_		Pressure	tor is above upper limit	Deviation		rectly
			set for operation	(user select-
					Material supply pres-	Decrease material
				able)
					sure is too high	supply pressure
					Failed transducer	Check transducer;
						replace if necessary
P3D_	67	Maximum Outlet	Outlet pressure of regu-	Alarm or	Incorrect set limit	Verify limit is set cor-
P4D_		Pressure	lator is above upper	Deviation		rectly
			limit set for operation	(user select-
					Material supply pres-	Decrease material
				able)
					sure is too high	supply pressure
					Failed transducer	Check transducer;
						replace if necessary
P1F_	68	Minimum Inlet	Inlet pressure to regula-	Alarm or	Incorrect set limit	Verify limit is set cor-
P2F_		Pressure	tor is below lower limit	Deviation		rectly
			set for operation	(user select-
					Material supply pres-	Increase crease mate-
				able)
					sure is too low	rial supply pressure
					Failed transducer	Check transducer;
						replace if necessary

3A2098H 71