Graco 3A2098H Appendix B Discrete Gateway Module DGM Connection Details

Appendix B - Discrete Gateway Module (DGM) Connection Details

Appendix B - Discrete Gateway Module (DGM) Connection Details

D-Sub Cable 123793

The D-sub cable 123793 is only compatible with single fluid plate systems. Systems with 2 fluid plates must use cable 123792 and breakout board 123783.

The cable length of interface cable assembly 123793 is 50 ft (15.2 m). The following table identifies the cable inter- face signals.

NOTE: See Appendix D - I/O Signal Descriptions, page 138, for I/O signal descriptions.

Wire Color	Description	Pin Type	D-Sub
			Pin No.
Green/Yellow	Isolated Logic Power Supply	Supply	51 and 27
Gray	Isolated Logic GND	Supply	70
Blue/Green	Dispense Ready	Digital Output	9
Brown/Green	Dispense Error*	Digital Output	11
Blue/Orange	Dispense In Process	Digital Output	12
White	Dispense Purge	Digital Output	15
Blue	Dispense Remote Start	Digital Output	16
White/Yellow	Style Bit 1	Digital Input	52
Blue/Yellow	Style Bit 2	Digital Input	53
Brown/Yellow	Style Bit 3	Digital Input	54
Black/Red	Style Bit 4	Digital Input	55
White/Red	Style Strobe	Digital Input	56
Blue/Red	Dispense Complete	Digital Input	57
Brown/Red	Error Reset	Digital Input	58
Black	Remote Start/Purge	Digital Input	59
Black/Gray	Dispense Valve 1	Digital Input	73
Brown/Orange	Dispense Valve 2	Digital Input	74
Brown	Command Value	Analog Input	1
Black/Yellow	Analog GND	Analog Input	2
White/Gray	---		3
Blue/Gray	Swirl 1 Speed Command ◆	Analog Input	21
Brown/Gray	Swirl 2 Speed Command ◆	Analog Input	23
White/Orange	Dispense Valve 3/	Digital Input	75
	Swirl 1 Enable◆
Black/Orange	Dispense Valve 4/	Digital Input	76
	Swirl 2 Enable◆
Black/Green	Digital CMD 1	Digital Input	77
White/Green	Digital CMD 2	Digital Input	78
Orange	---		N/C

◆Swirl-related inputs apply only to systems with Swirl Dispensers.

*Dispense Error may be active high or low, depending on the setting on the Gateway setup screen. See Discrete Gateway (Automation) Setup Screen, page 104.

3A2098H 115