Graco 3A2098H important safety instructions Install Command Cable Kit 24B694, Fcm

Installation

Install Command Cable Kit 24B694

Follow this procedure if using the command cable kit.

1.Install bulkhead fitting (included in the kit) into the empty hole on the fluid plate. See FIG. 16 on page 25.

2.Connect one end of the extension cable (included in the kit) to connection 5 on the FCM and the other end of the cable to the bulkhead fitting.

3.Connect command cable to bulkhead fitting and wire to automation controller per the following pinout table.

		Function
FCM	Command	Dispense Trigger Source:
Port	Cable Wire	‘Command Cable’ or	Dispense Trigger Source:
Pin #	Color	‘Combined’	‘Command Cable 3x’
1	White	Command voltage (0-10 Vdc)	Command voltage (0-10 Vdc)
2	Brown	No connection	Valve 3 dispense trigger (*sourcing
			input)
3	Green	Dispense trigger (*sourcing input)	Valve 1 dispense trigger (*sourcing
			input)
4	Yellow	No connection	Valve 2 dispense trigger (*sourcing
			input)
5	Gray	Dispense trigger ground	Dispense trigger ground
6	Pink	No connection	No connection
7	Blue	Command signal ground	Command signal ground
8	Red	No connection	No connection

NOTE: Command cable inputs are not isolated from

PCF 24 Vdc power.

*To turn on the dispense trigger, connect the dis- pense trigger pin to the dispense trigger ground pin (pin 5).

26 3A2098H