Invacare Tracer EXIR INSTALLING/ADJUSTING the ANTI-TIPPERS, Installing the ANTI-TIPPERS Figures 1

ANTI-TIPPERS/WHEEL LOCKS SECTION 8

Section 8 - Anti-tippers/Wheel Locks includes the following:

Installing/Adjusting the Anti-Tippers

Using/Adjusting the Disk Wheel Locks

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure all attach- ing hardware is tightened securely - otherwise injury or damage may occur.

INSTALLING/ADJUSTING THE ANTI-TIPPERS

WARNING

Anti-tippers are specific to the different seat-to-floor angles and/or seat- to-floor heights. Refer to the chart in this section of the manual for cor- rect usage and adjustment. If these requirements CANNOT be achieved, DO NOT use the wheelchair. Contact a qualified technician. Any changes to the seat-to-floor angle or seat-to-floor height may require different anti-tippers.

If so equipped, anti-tippers MUST be attached at all times. Inasmuch as the anti-tippers are an option for this wheelchair (You may order with or with- out the anti-tippers), Invacare strongly recommends ordering the anti- tippers as a safeguard for the wheelchair user.

Anti-tippers MUST be fully engaged and release buttons fully protruding out of adjustment holes.

Ensure both anti-tippers are adjusted to the same mounting hole.

INSTALLING THE ANTI-TIPPERS (FIGURES 1 AND 2)

NOTE: To ensure the correct model anti-tipper is used refer to FIGURE 1. Measurements for anti- tippers are approximate and are taken with extension tube in BOTTOM hole position.

Wheelchair	Seat-to-Floor Height	Anti-tipper (measurements in inches)
Model	in inches	Length	Height	Model	Part Number
Tracer EXI	17-1/2 to 19-1/2	13-1/2	3-1/4	1360	1058836
Tracer EXI	15-1/2 to 17-1/2	11-5/8	2-3/4	1360A	1058752
Tracer EXI FF	21	12	2-3/4	9758	1086190

Anti-Tipper Height
Flat Surface	Bottom Position
Anti-Tipper Length

FIGURE 1 - ANTI-TIPPER LENGTH

ANTI-TIPPERS/WHEEL LOCKS

Part No. 1110547 35 Tracer® EXI