FRONT RIGGINGS | SECTION 3 |
Section 3 - Front Riggings includes the following:
Installing/Removing the Front Riggings
Footplate Height Adjustment
Adjusting the Elevating Legrest Assembly
Heel Loop Replacement
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may occur.
INSTALLING/REMOVING THE FRONT RIGGINGS (FIGURE 1)
NOTE: This procedure applies to the swingaway footrests and the elevating legrest.
FRONT RIGGINGS
INSTALLING
1.Turn the front rigging assembly to the side (open front rigging is perpendicu- lar to wheelchair).
2.Install the hinge plates on the front rigging assembly onto the hinge pins on the wheelchair frame.
3.Push the front rigging assembly to- wards the inside of the wheelchair until it locks into place.
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
4.Repeat this procedure for the other footplate assembly.
| Front Rigging Release | |
| Lever | |
| Front Rigging | |
| Assembly | |
| Footplate | |
Hinge Pins | Hinge | |
Plates | ||
|
NOTE: Swingaway footrests shown.
FIGURE 1 - INSTALLING/REMOVING
THE SWINGAWAY front rigging
5.To release the front rigging, push the front rigging release lever inward, rotate front rigging outward.
REMOVING
1.Push the front rigging release lever inward
2.Rotate swingaway front rigging assembly outward.
3.Lift the swingaway front rigging assembly off of the hinge pins.
Part No. 1110547 | 21 | Tracer® EXI |
