Functions and settings
Switching the input signal detection setting
Functions and settings
To return to the previous display/ To cancel during setting operation: Press [ RETURN].
Play
24
Most sources can be played with “AUTO ” (factory setting).
However, in the following cases, change the input signal detection setting.
•When the beginning of the song is cut during playback of CD, set to “PCM ” (PCM FIX).
•When the signal is not detected during playback of DTS sources, set to “DTS ” (DTS FIX).
•When noise occurs, return the setting to “AUTO ”.
1. Press and hold
The setting items are displayed. (➜ page 21)
2.Press [w][q] to select “INPUT MODE ” and press [OK].
3.Press [w][q] to select the input and press [OK].
Input: TV, DVD, AUX1, AUX2
4. Press [e][r] to select the detection method of input signal and press [OK].
AUTO : Automatic detection
PCM : PCM (from CDs) digital input fixed
DTS : DTS digital input fixed
Factory setting: AUTO
Repeat steps 3 and 4 to change setting.
5.Press [ RETURN] several times to select “EXIT ” and press [OK] to finish the setting.
Reset (factory settings)
The operation settings for the system will be initialized to the settings made at the time of shipment.
1. Press and hold
The setting items are displayed. (➜ page 21)
2.Press [w][q] to select “RESET ” and press [OK].
3.Press [e][r] to select “YES ” and press [OK].
YES : Choice for resetting NO : Choice against resetting
•To cancel, select “NO ”.
Note
•All the settings are reset when you select “YES ” and the Input Selector automatically switches to “BD/DVD ”.
•If you select “NO ”, you will return to step 2. To exit setup mode, press [ RETURN] a few times to display “EXIT ”, and then press [OK].
•The contents of the speaker setting are not reset. However, the contents set at “Changing the number of speakers to 4” (➜ page 15) are reset.
When other equipment (mini component system, AV amp, etc.) manufactured by Panasonic operates with the remote control operations of this system
When using this system’s remote control, other equipment may operate. In this case, switch this system’s remote control code to “REMOTE 1 ”. Do the following to set the same code number for this main unit and remote control.
Setting the main unit
1. Press and hold
The setting items are displayed. (➜ page 21)
2.Press [w][q] to select “REMOTE ” and press [OK].
3.Press [e][r] to select “1 ” and press [OK].
Factory setting: 2
•You cannot finish the setting mode until the setting on the remote control is changed. Go to step 4.
•To set the remote control code to 2, select “2 ” in step 3 and press [OK].
Setting the remote control
4. Press and hold [OK], and then press [TV] (more than 2 seconds).
TV: Remote control code 1
BD/DVD: Remote control code 2 (factory setting)
•Select the same number as the code number you have selected in step 3.
•To set the remote control code to 2, press and hold [OK] in step 4, and then press [BD/DVD] more than 2 seconds.
5.Press [ RETURN] several times to select “EXIT ” and press [OK] to finish the setting.
Note
If different codes are set between the main unit and remote control, the error message “REMOTE 2 ” or “REMOTE 1 ” is displayed.
VQT2R70