SEAT BACKAND

SECTION 5

SEAT AND BACK

 

 

 

EXI WITH FIXED FRAME (FIGURE 4)

Removing Lower Mounting Hardware (DETAIL "A").

1.Remove the existing back and seat upholstery from the wheelchair. Refer to RE- PLACING THE BACK UPHOLSTERY and REPLACING THE SEAT UPHOLSTERY in this section of the manual.

NOTE: If adjusting the seat width of the wheelchair, back and seat upholstery as well as the crossbraces MUST be replaced.

2.Remove the four (4) screws and locknuts that secure the insert tube to the lower wheelchair frame.

3.Remove the inserts from the rear of the wheelchair.

4.Remove the hex screw and locknut that secure the two (2) existing crossbraces together.

Removing Upper Mounting Hardware (DETAIL "B").

1.While pushing down on the rear seat guide, pull up the front seat guide until the front seat guide releases from the wheelchair frame.

2.Pull the crossbrace away from the rear seat guide.

3.Repeat STEPS 1-2 for opposite crossbrace.

4.Reverse STEPS 1-3 to assemble the upper mounting hardware.

5.Reverse STEPS 1-4 in REMOVING LOWER MOUNTING HARDWARE in this section of the manual to reassemble the wheelchair.

 

DETAIL "A" - REMOVING LOWER

 

 

MOUNTING HARDWARE

Crossbrace

DETAIL "B" -

 

Locknut

 

REMOVING UPPER

 

MOUNTING

 

 

HARDWARE

Insert Tube

 

 

Hex Screw

Rear Seat Guide

 

Screw

Wheelchair

Crossbrace

Frame

 

Front Seat Guide

 

FIGURE 4 - ADJUSTING SEAT WIDTH - EXI WITH FIXED FRAME

Tracer® EXI

30

Part No. 1110547

Page 30
Image 30
Invacare Tracer EXIR manual EXI with Fixed Frame Figure, Detail a Removing Lower Mounting Hardware