Graco 3A2098H important safety instructions Swirl Events and Errors, Refer to Swirl Control

						Errors
Event	Gateway		Event
Code	Error No.	Event Name	Description	Event Type	Cause	Solution
			Fluid Plate Events and Errors
MB3_	98	Maintenance due	Maintenance due on	Advisory	The active time total-	Service Component
		- V3 Orbiter	valve 3 swirl orbiter		izer for the swirl dis-
					penser associated	If necessary, reset
					with this valve and	totalizer
					fluid plate exceeded
					limit setting
MB4_	99	Maintenance due	Maintenance due on	Advisory	The active time total-	Service Component
		- V4 Orbiter	valve 4 swirl orbiter		izer for the swirl dis-
					penser associated	If necessary, reset
					with this valve and	totalizer
					fluid plate exceeded
					limit setting
Swirl Events and Errors
Event	Gateway		Event
Code	Error No.	Event Name	Description	Event Type	Cause	Solution
			Swirl Events and Errors
CBR_	---	Swirl Communi-	Swirl communication	Alarm	The ADM lost commu-	Restore communica-
		cation Error	error with ADM		nication with the Swirl	tions
					Control DGM
CDR_	---	Duplicate Module	Duplicate Swirl Control	Alarm	Two or more Swirl	Verify that all Swirl
			DGM Detected		Control DGMs have	Control DGMs have
					the same rotary switch	proper rotary switch
					setting	settings. Reset mod-
						ule after changing
						rotary switch setting.
						Refer to Swirl Control
						DGM section, page 19.
EAD_	---	Maintenance	Maintenance mode	Advisory	Swirl maintenance	No action required
		Mode Entered	entered	(self-clear-	mode entered
				ing)
EBD_	---	Maintenance	Maintenance mode	Advisory	Swirl maintenance	No action required
		Mode Exited	exited	(self-clear-	mode exited
				ing)
MBD_	---	Maintenance	Maintenance due on	Advisory	Swirl active time total-	Service Component
		Due - Orbiter	swirl orbiter		izer exceeded limit set-
					ting	If necessary, reset
						totalizer
WBD_	---	Swirl Motor Fault	Motor speed is outside	Alarm	Cable disconnected	Verify cable connec-
			the +/- 50% tolerance			tions to swirl board,
			range for at least 5 sec-			swirl motor cable, and
			onds while operating			swirl orbiter
					Shorted motor cable	Replace swirl motor
					(amber LED on swirl	cable (55 ft)
					board will be on)
					Orbiter bearing failure	Replace bearing
					Motor defective	Replace swirl orbiter

3A2098H 75