Graco 3A2098H important safety instructions System Setup, Configure System

System Setup

System Setup

Overview

The PCF system compensates for temperature, flow, or pressure fluctuations. However, if there is a hardware change on the supply system or the dispense material is changed, the PCF system must be set up again.

After material is loaded into the supply system, set up the PCF system using the Setup screens. The following procedure outlines the major system setup steps. The following subsections provide instructions to complete each setup step. Once these steps are complete the module is ready for operation.

NOTE: See the Advanced Display Module (ADM) sec- tion, page 17, and Appendix A - Advanced Display Module (ADM), page 99, for detailed operating instruc- tions for the display keypad and each screen.

1.Configure System, page 32.

2.Configure Control Settings, page 33.

3.Configure Mode Settings, page 34.

4.Configure Delay Settings, page 34.

5.Configure Flow Meter Settings, page 35.

6.Configure Pressure Loop Settings, page 35.

7.Adjust Pressure Sensors, page 36.

8.Configure Errors, page 36.

9.Setup Maintenance Schedule/Parameters, page 37.

10.For systems with swirl dispensers only:

a.Configure Swirl to valve association and error type, page 37.

b.Configure Swirl settings, page 38.

11.Configure Gateway Settings, page 38.

12.Setup Styles, page 38.

13.Configure Advanced Settings, page 38.

Configure System

Define the number of installed fluid plates (called “Dis- penser” on this screen) and number of installed swirl dispensers. If a fluid plate is listed as “Uninstalled” the screens for that fluid plate will not appear in the run or setup screens.

1.With the system in setup mode, navigate to the Sys- tem screen.

2.Press to access the fields to make changes.

3.Use the arrow keys to navigate to the desired field.

4.Press to open the drop-down list, and select

the desired setting. Press to accept the selec- tion.

5.Repeat for the other Dispensers and Swirl Dispens- ers.

6.Press to exit edit mode.

FIG. 19

32 3A2098H