ASSEMBLY
INSTALL SEAT (See Fig. 2)
Adjust seat before tightening adjustment knob.
•Remove adjustment knob and cup washer securing seat to cardboard packing and set aside.
•Remove seat from the cardboard packing and set seat aside. Remove the cardboard packing and discard.
•Place seat on seat pan so all three (3) bottom pads are positioned over large slotted holes in pan.
•Push down on seat to engage pads in slots and pull seat towards rear of tractor.
•Pivot seat and pan forward and assemble adjustment knob and cup washer loosely. Do not tighten.
•Lower seat into operating position and sit in seat.
•Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down.
•Get off seat without moving its adjusted position.
•Raise seat and tighten adjustment knob securely.
SEAT |
PAN |
PADS |
36 |
30 |
0 |
CUP WASHER |
ADJUSTMENT |
KNOB |
03035 |
FIG. 2
CHECK BATTERY (See Fig. 3)
•Lift seat pan to raised position and open battery box door.
•If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at
SEAT PAN 
LABEL
BATTERY
BOX DOOR
TERMINAL
TERMINAL 
02021
FIG. 3
NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.
WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a
TO ROLL TRACTOR OFF SKID (See Op- eration section for location and function of controls)
•Raise attachment lift lever to its highest position.
•Release parking brake by depressing clutch/brake pedal.
•Place gearshift lever in neutral (N) position.
•Roll tractor forward off skid.
TO DRIVE TRACTOR OFF SKID (See Op- eration section for location and function of controls)
WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a
•Be sure all the above assembly steps have been com- pleted.
•Check engine oil level and fill fuel tank with gasoline.
•Sit on seat in operating position, depress clutch/brake pedal and set the parking brake.
•Place gear shift lever in neutral (N) position.
•Raise attachment lift lever to its highest position.
•Remove key from bag and start the engine (see "TO START ENGINE" in the Operation section of this manual). After engine has started, move throttle control to idle (slow) position.
•Depress clutch/brake pedal into full "BRAKE" position and hold. Move gearshift lever to 1st gear.
•Slowly release clutch/brake pedal and slowly drive tractor off skid.
•Apply brake to stop tractor, set parking brake and place gearshift lever in neutral position.
•Turn ignition key to "STOP" position.
7Continue with the instructions that follow.
